Wireless

I have an existing network with Non H-REAP AP's and I am installing a remote office using H-REAP APs. I am using some of the same SSIDs on both sites and have enabled the H-REAP setting on the WLANs.The design guide I looked at had this note;Note: Ac...

Hi,Has anybody configure secure mobility groups on 4402/4404. I put mobility secure-mode enable command on both controllers. Mobility Protocol Port status has change to 16667 (after reboot) but I have Data Path Down. Do I have to configure something ...

I have 2 SSID in my wireless network. 1 for the cooperate users and 1 for the guest. The guest SSID is broadcast and when a user open an IE, they will get a screen for user name and password. My cooperate users are using AD and integrated with ACS 4....

Hi,I have a metwork with 35 AP 1242 (only 2.4ghz band) and 30 7921g.I'm using a WLC 4404 version 4.2.61 7921G version 1.1.1, CCME version 4.1, AP IOS 123-7JX.The coverage seems to be good and also the overlap.The problem is: some times casually and a...

I am running device troubleshooting in cisco works on a 1200 series acces point. I am getting the followinf error message: VTP Disconnected Domain DomainName:NO_VTP Do I need to upgrade IOS on all AP's??

We have a 2100 Wlan controller set up with multiple wlans.We are having problems on the Guest VLAN in that everytime a user tries to authenticate via Web Auth, they fail and are redirected to the username/password page.Local accounts have been added ...

I am going to deploy a WLC 4402 to about 30 APs of AIR-LAP1131AG-E-K9 over WAN.The solution will use for the guest to access to only Internet.The guest will have an account by Guest Access Lobby Ambassador from WLC, Clients get IP from DHCP server.In...

Hello,I have configured a Cisco call manager express 4.3 on a Cisco 2821 with a VWIC2-1MFT-T1/E1. I have 10 grouped lines from my operator.The problem is that when someone calls from the outside it appears "from unknown number". I would like to enabl...

Hi, I want to install an H-REAP AP in a remote office on a switch access port (none trunk). The AP IP and users on the local switched WLAN will be on the same network/Vlan. I want to put the AP in H-REAP local switching on one SSID and central switch...

Greetings All,I am putting in a ACS SE and ACS. Both Running 4.2 Build 124 Patch 6. Can you give a clear instruction set to sync the two. I am looking through the user guides and the process seems somewhat unclear on a few details.thanks.

Hi to all,I have some client that use Nokia E61 as CME phone and internet in a wireless lan with two AP 1200. On this AP are configured two SSID one with WPA (EAP and radius) authentication and an other SSID WPA with preshared key, for guest and for ...

Currently running Wism on 4.2.61 and have another to put MESH code on. Our WCS release is 4.2.62.0 Would appreciate input on the right mix of releases to move to supporting mesh on one wism and no mesh ap's on the other - for now. thx

We have a guest wlan and want to apply an acl to allow guests to only access http and https on the guest wlan only. Any ideas, have tried a couple myself with no luck.

on my aironet 1130AG, my wireless in my building is up, but one of the guest accounts isnt working... i attached the config. NO CHANGES WHERE MADE, just the guest account stopped working a few days ago... HELP!