Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
Resolved! WLSE -> WCS upgrade license question
Hello,We need to upgrade our WLSE to WCS but our sales people bought the wrong license (WCS-Standard-K9) Is it possible to upgrade the WLSE to WCS with this license and just get the conversion CDs needed from you ?
I have a 150 ft Outdoor Ethernet Cable (AIR-ETH1500-150=) for the Mesh Radios and I would like to know if I can cut the cable to make it shorter and reterminate the RJ45 end. Does it require a special type of RJ45 connector?
Is there any way to figure out if a MAC address takeover has happened on one of your access points? Something similar to checking on a switch if the same IP/MAC pair is broadcasted on two separate ports.Thanks,Octavian
Municipality wishes to provide wireless service for its residence in various facilities (senior center, recreactional center). Looking for best hardware/software solution to provide stable and secure wireless access, and provide features for content ...
Can I use power over ethernet to supply the Injector with power?
can you send me details on what model of cisco brand to be used to setuo a network with wireless solution.
In the 1510 installation guide I have seeen that the antenna has been directly mounted on the device.Is there any option to extend the AP to antenna connection up to 25 m using additional cable ? If so, what is the Cisco cable type available ?
What are the benefits/drawbacks of using 4 controller-based APs to contain a rogue AP vs using just one. If I understand it correctly a single AP can never be set to contain more than 3 rogues, and will never use more than 30% of its resources to do ...
In an ALL 1510 outdoor mesh network, is there any reason at all not to uograde to that new mesh only version of firmware? I am on 185 right now but not in full 100% production.Upgrading later may cause me sume interruption.
Hi,Say I have 2 LAPs on a WLC.Then I enter,config auth-list add mic <AP mac>for one of them.Does this mean the other LAP,1) Has it's current LWAPP tunnel disabled2) Can't establish LWAPP tunnel next time it resets? Must I enter this command for the 2...
I have a couple of BR1310 with the integrated antenna. I am getting an extremely weak signal out of the antenna about a 70 DB loss sitting 10 feet away from the AP. Is there an IOS command to the enable the integrated antenna, I also opened one of ...
Resolved! Cultural Question : how to say WLAN
Hi all, being a non-native speaker and doing an English presentation soon, I wonder if "WLAN" is often used instead of "Wireless LAN" or just "Wireless".The pronouncation of WLAN as "double-u-LAN" sounds odd to me - I'd prefer to speak of "wireless",...
Hello,Newbie here. I was able to telnet into an Aironet 1100 ap. I like to ftp its image and config files so that I can download it onto several other Aironet 1100. Does the FTP mean a ftp server in our network that I can access?
We recently changed our T1s over to another vendor and, as a result, had to get new external IPs. I have this Aironet 1200 WAP that is using the old external IP address. I need to know how to change it. Unfortunately, the person that set it up no ...
All,I have three SSIDs/WLANs and 100APs. Now, one of the WLANs is a guest-WLAN which should only bee seen on 16 out of 100APs.If I enable the guest WLAN globally then I would need to apply the WLAN override template to all APs and then I would need t...
