Wireless

Hi,Is it possible to have one central user (guest) database with two Wireless Lan Controllers. Now we create users (lobbyadmin) local on one wireless lan controller. But the AP's connected to the secondary WLC won't recognize this users. Is there an ...

Hi, I have a 877 which I am troubleshooting some mDNS (224.0.0.251:5353) issues.One client sends a mDNS request, the router sees it (packet debug) but the packet is not received by any other client on the wireless LAN.Given it is link local I don't b...

I have a wism installed on my 6513 but the moment i assign ports g12/1-4 to Po1 and Ports G12/5-8 to Po2 the are no coming up the configuration of the Ports including Po1 and Po2 are as follows:interface range GigabitEthernet12/1-4switchportswitchpor...

When I enable WLAN override for a specific AP, and I select only 2 of the 5 avaliable WLANs, all SSIDS disapper for that AP. My WISM is running code 4.1.171.0. Does anybody know if this is an issue. The AP is an AP1131.Thanks for your help.

Hello all,Can I use AP1131AG for air relay?Here is the scenario:--wired--AP1131AG--wireless--AP1131AG--wired.Thanks.

What would the estimated output power level be when using a 1242 with rubber ducky antennea in warehouse be to get 1 1242 per 8,000/sq ft for use with 7921Gs?I'm guessing 6mw-12mw? I'm guessing that at 50mW I'd have way too much power for 1 1242 per ...

DearsI have 4 WLCs,3 are active and one is backup Controller with AIR-LAP1522HZ-E-K9So mesh technology i need i-e- One Rap will be connected through ethernet and 5 MAPs will be through wireless with 100 meter radius and start topology.RAP will be in ...

I am trying to get our Cisco 1130 AP's to use Radius MAC Authentication using a freeradius server. We have been successful with other AP's (Proxim, Netgear) but haven't been able to get the Cisco 1130 to work. I have attached 2 files. One is the runn...

HiWe are planning to implement a wireless network with Cisco LWAP 1240AG AP's with Cisco AIR-ANT4941 antenna.I understand that you should have AP's around the inside edge of the building spaced between 8-10 metres depending on the survey and then wor...

Hello,I have a 1130AP and try to associate the AP witha WLC at a remote site. The AP grab an IP address and resolved the Cisco-LWAPP-CONTROLLER to the IP address of the WLC. I could ping the WLC from the AP cli and vice versa. However the AP is not g...

I have a Location 2710 that was being seen by the WCS.It worked fine for almost a day. But strangely it started to being not seen by the WCS.I tried to associate again the 2700 with the WCS but I received a message from the WCS:No response from Locat...

For a stand-alone access-pointIs there a limit for maximum number mac-adresses?

I want to enable wirless connections for data transfer from boats when they arrive in port. I'm thinking of using a mesh network to cover the quay areas back to the main office and either use mesh nodes or access points on the boats themselves. I'll ...