Wireless

I've setup my 1130ag like the cisco walkthrough for wpa2 support. When I try to connect with my Thinkpad R60 with XP SP2 (with wpa2 hotfix) or my Acer with Vista, it just keeps popping up the credentials prompt. If I switch to WPA2-PSK, they both wor...

I am not able to access the GUI of the wireless controller - If I console into the wireless controller I can ping the management IP address but if I console into the switch I cannot ping the wireless controller.I think someone may have screwed up the...

Currently developing a solution to convert simple Windows wired domain to wireless.Considering using ten Aironet 1100 APs for 200 Windows XP clients on a single network/domain. Clients will authenticate using certificates with RADIUS (IAS) over EAP-T...

Hi,I am working on setting up a new WLAN. We purchased a Cisco 4402 WLAN controller and several 1131AG access points. I have the access points set up and talking to the controller, but I can't get clients logged on.For security I am using MS IAS Radi...

I am looking for an outdoor enclosure that will work with my access point. I already have an injector. just looking for a water proof enclosure to mount outside.

dear sir, We wish to setup 4-5 cisco wireless access points AIR-AP1242AG on area that surround with radio x . We are not sure for the radio x impact on wireless ap implementation. We just afraid it might happen explosion or any negative impact might ...

Having replaced 44 Dlink APs with a 4402 and 1252 A/B/N APs within an educational environment, I find myself with a slower wireless network than before (I say slow, impossibly slow to the point of failure)Where as 1 Dlink AP would happily take 15+ cl...

All, on a ceiling mount (or in this case a production floor (steel i beam mount), what director should the 2 2.4ghz 2.2dbi dipole w/RP-TNC antennas, be pointing? Down?

We have one 4404 and 12 Ap's 1242: two on every floor. I want is AP's on every floor have their own SSID (differ from others). How can I do it?Any ideas greatly appreciated.

Hi Everyone,Here's a bit of a quandary that I can use some help with. Our company wants to install a wireless access point in a pubic place and then publish the one word English "key" on a screen where the person must then enter it in to their laptop...

This may be a dumb question, but I would like someone else to confirm that the lightweight APs who are connected to a WLC cannot have individual "allowances" made. For instance, I cannot implement MAC restrictions on one AP in a given area versus the...

hi,Does anyone know if there is a WCS demo, ideally fully funtioning, maybe a 30 day trial?cheerspaul

I just finished a deployment of WLC 4.2.112.0 with about 30 AP's. Everything is working fine, but the WLC is showing an AP as rogue, not wired with a radio MAC address that is the same as one of my functioning registered AP's.It doesn't appear to be ...

We have just set up a WLAN. We have a 4402 controller and 1131AG access points. We have a lot of consultants, guests, presenters, etc. roll through who need Internet access. I'd like to setup a WLAN that is seperate from our production network and ge...