Wireless

HelloI was looking at the Cisco's 871w specification earlier. I noticed that it has a peak power of 245mW with the average of 80mW for the 802.11B.What does the "peak" really mean? There is no where in the 871W CLI that will allow me to increase the ...

I have 2 user groups (Staffs and Students) on Windows AD and I created 2 WLANs using Cisco ACS to authenticate users. I want Staffs access wlan STAFF, Students access wlan STUDENT respectively; Staffs are not allowed accessing wlan STUDENT and vice v...

Hi,we are currently working on getting an standard architecture into our company regarding WLAN security access.I would then like to year what do you think about it in terms of security (we are not looking into the state of art security, but a level ...

Can someone give me a good reason to use a seperate controller in a DMZ for guest users versus just trunking a DMZ VLAN to the controller. Certainly it makes sense to have a guest controller when you DMZ is not accessable to the controller locations ...

Hi.I have problem with Aironet 1100 AP where machines connected to this AP cannot communicate among each other (cannot ping). However, each workstation can ping the AP. Also the AP can ping the workstations.There are no firewalls between.Arp table on...

Hello,I recently purchased a Cisco Access Point (Aironet 1200 series 1231) and have configured it with success but the radio signal is very weak and it doesn't come with the antenna. I thought it came missing, but on the manual says very clearly that...

Hello,I have a 877W with a c870-advsecurityk9-mz.124-4.T6 IOS.And Id like to configure it in Universal Client Mode, I've seen in the doc that it's possible , but can't find any doc on how to do it.When I go in "station-role" in the dot11 interface, I...

I'm having a problem with broadcom adapters not being able to connect to our 1240AG access points when using WPA-PSK. Other manufacture's adapters work just fine.

We have 4 WiSM controllers; one of which is defined as the the Master Controller.After APs have joined the Master Controller, we have changed some of them to use another controller as their primary controller. Even though the WCS shows these APs as h...

Hey Folks,Is there a way to change the backsplash and gui layout on a 7921? We would like to put our company logo and possible rearrange the icons on the screen.Is this feasible?Thanks!

Summary:How to switch users from using Intel ProSet to manage their legacy SSID w/ WEP to using Windows Zero Config w/ both legacy & new SSID's automatically?Detail:Some of our sites are still using WEP for wireless encryption (believe it or not) ove...

Hi,I'd like to have explicit control over which LAPs can Join a WLC.With Autonomous AP you can a RADIUS account for the AP (I'm not talking about the wireless client) so AP must auth. to work on the network.Can a similar thing be done with LAP?I noti...

Folks, imagine I am designing network connectivity for a 2,000 sq. ft. auditorium room.I am planning to provide few Ethernet network drops on the front section and back of the room. Then for all other seats, I am planning to rely heavily on Cisco acc...

Kind of new to the more advanced Wireless stuff, and must making sure I'm on the right track. We have the following:4400 series WLCs w/ 4.1 software1242 APsSecureACS 4.0 serversUnix LDAP serversWindows 2000 servers running ADMix of Windows, Linux, an...

I am just having a horrible time implementing Migration mode. I'm sure it's me. 8-)I am running an autonomous 1240AG. It is currently set up as static WEP/PSK.I would like to "add" WPA/PSK to the existing SSID.Is this possible? or does migration mode...