Wireless

Hi,I want to synchronise a WLC2006 with a NTP server. After having set the NTP server IP address with the GUI, the ping operates properly, but the WLC keeps the date and time set manually. The NTP server is connected to the port supporting the dynami...

Ok, so I've read the documentation but only seems to hold half the answer to half the equation. Scenerio, I have Network A with WLC A, all of my AP's going to WLC A, wether they are in Network A or B. In Network B, I have WLC B where nothing is curre...

why is 871w so hard to configure out of hte box? i used tech republic, and its no good

Users at one of my autonomous based sites are frequently being kicked off wireless.I have a user who is sitting in one place close to a WAP. For some reasoning he is moving between 3 WAPs.all waps have the following version of code;Cisco IOS Software...

I just installed the latest signatures and I get the message: SDM is unable to get signature details from router".Any suggestions on how to correct this?

I am getting ready to submit requests for equipment replacement and I am considering replacing our 4402s. I was not able to see any perf comparisons between the wism and the 4404 units. I assume that the wism would be better given that it would be on...

I have 2 1300's in bridge mode. Is there a way to see what the connect rate is real-time? Also, what are "normal" stats on the detailed stats page, e.g. CRC's, packet retry's, etc. Thanks in advance,GL

Hi All,I just need some help in configuring the following.I have 2 LANS separated by about 150feet. I need to connect the 2 LANs together.LAN1 has a 6509 switch with 10.35.80.x network. The ACS servers needed for authentication are in this network. L...

I have an AP1220 that have the radios upgraded and converted for LWAPP. The led status lights atlternate blinking with the middle showing red. Can someone refer me to a document that gives me the interpretation of the different led combinations and w...

Hello and happy New Year,I am trying to generate a PEM file to upload to my Cisco 4402 Wireless LAN Controller. I have an unchained certificate from Verisign and have followed the instructions at http://www.cisco.com/en/US/tech/tk722/tk809/technologi...

tried put sis laptop Dell 610 Lati.on home network with desktop; Road runner using linksys router in between cable modem & Netgear wireless.Both XP;could'nt get help from Brighthouse.Can any1 help?????

I'm trying to figure out if it is possible to feed this accesspoint with the Cisco Pre-standard Inline Power from a 3524-PWR switch.When I turn on the Accesspoint it shows that there is not enough inline power available to turn the radio's on. Accord...

Hello,I have to manage a wlc 4404. According to me he acts strange.Only ports 1,2 and 3 are connected. The ap-manager and the management are linked at port 1. So far so good.If I look at the wireless-tab I see all AP's are connected at port 3 !! All ...