Wireless

Hi, I am implementing dot1x with PEAP for wire and wireless access, before I get CA running, I am using ACS server self-signed certificate. However, XP client won't be able to authenticate if I have the "validate server certificate" box checked. I di...

Hi, are these AP ready for sale now, cause I do not find them in the ordering tool?For them to work with 802.11g standard, should I configure the same antenna types used for 1200 series, and is it necessary to place the 6 antennas?

Recently added WPA2 and wlans in our test lab to 350's and now rf units are having issues staying connected and timing out. Logging history reports following message constantly: Interface Dot11Radio0, Deauthenticating Station Reason: Disassociated be...

What do guys thinks between the following product for a site survey:OmnipeekCognioair magnet

I was wondering if anyone has worked with Innerwireless with Cisco LWAPP solution. I want to know if there are any drawback to using innerwireless instead of the normal AP design. Critical applications will be used on this wireless system which will ...

Hello,I'm using AIR-AP1232AG.I did ping test to gateway and the result is not so good like below.What should I do for this?Pinging 10.1.1.1 with 32 bytes of data:Reply from 10.1.1.1: bytes=32 time=1ms TTL=255Reply from 10.1.1.1: bytes=32 time=2ms TTL...

Hi,Is there a way to tell remotely if an antenna has been connected to a specific radio interface (just as you are able to see a serial cable connected to a serial interface) ?Thank You,Dragos

I just converted one IOS AP to LWAPP. While the conversion was smooth, I can not use the 802.11a radio. Here is the output for :show ap config 802.11a APAP Regulatory Domain............................. -NWell I know that is supposed to e newZealand,...

We have a situation (new setup) where clients can associate to either the 871-w or the 1131 w/open authentication and reach Internet. Users can also roam (according to the 1131 console) to the 871-w and continue to work. Users cannot roam back to the...

Hi NetPro, anyone can tell me how to resolve this ? i have check from CCO, no relevant inform. Error Message DOT11-4-CKIP_MIC_FAILURE: "CKIP MIC failure was detected on a packet (Digest 0x%x) received from %e)." Explanation CKIP MIC failure was detec...

I need a recommendation of some of the devices to cover up a diameter of 600 metersSomebody would be able to give me some piece of advice

I have a project with a customer and a remote campus. The remote campus currently consists of two cottages (35?x147?) separated by ~800ft with clear line-of-site. The first cottage has an existing DSL Internet connection with D-Link wireless router a...

Hi, I have a problem witch AP 350, hope that I could help. CLI: ? Loading "flash:/c350-k9w7-mx.122-13.JA1/c350-k9w7-mx.122-13.JA1"...flash:/c350-k9w7-mx.122-13.JA1/c350-k9w7-mx.122-13.JA1: no such file or directory Error loading "flash:/c350-k9w7-mx....