Wireless

Hello,What are the main functions of the Radio Manager in the WLSE :- rogue access point detection YES ?- interference detection YES ?- client walk about YES ?- AP scanning NO ?- RM assisted configuration NO ?- self healing and auto re-site survey NO...

How often would you change the passwords for Guest and Employee SSID's? Would you change them every 6 months? What method do you use to notify Guests and Employees that the passwords for SSID have been changed? For Guest, would you place the document...

Dear All,we purchased a Cisco 1242AG and a 1310G Access Point and in the DataSheet it was specified that these APs support Power-over-Ethernet. The problem is we don't see any RJ-45 port in either AP which could be used for connecting the AP to an Po...

I keep getting this error on the controller debug logs"Received a Discovery-Request on an unsupported VLAN 7"I have my APs tied to VLAN7 and i have option 43 defined on the DHCP VLAN 7 lan scope to point to the controller management interface.all swi...

Hello!I'm experiencing a problem with H-REAP users.I have set up a WLC 4402 and WLAN with WPA2+DOT1X. Controller authorizes clients via RADIUS. H-REAP access points (1131AG) are connected through a 2Mbits link and local switching is enabled for the W...

I was trying to update the ios and my tftp server lost connection to the wlc and the entire controller rebooted, loading back to only a "grub>" prompt. Is there any way I can reinstall the image or something!!! Please HELP!!!!!!

I am in the process of adding the g radio upgrade kit, AIR-MP21G-A-K9 to an older Aironet 1200 b radio. I follow the steps and then boot the access point. Everything comes up fine, but when I perform a 'show version', it still shows the model number ...

I can not find on Cisco's website what version of code must be on my 3825 router to support the NM-AIR-WLC6-K9. Currently c3825-ipbase-mz.124-3g.bin is on the router and it does not recognize the controller. Also are there any sample configurations. ...

I've got a big stack of statically-addressed autonomous AP1130s which I'm converting to LWAPP. Unfortunately, the LWAPP conversion tool loads the AP with the IOS_STATIC_IP_ADDR from env_vars, not the address from the running config. So my question is...

Just about every time I check my messages from my 7940 IP phone, I get a couple of receipt messages. What are they?

Hi,what is the maximum number of users for each AP,I'm using AP 1130, and is thier any Cisco AP supporting 802.11 Nthanks,

large pings fail over Layer 3 LWAPP when RAP's are connected over WAN (Internet)also cannot browse sites etc.The RAP's join and clients can get IP adress from DHCP server, but cannot ping over 1399b to default gateway.Layer2 seems OK - 10-20ms latenc...

I have an AP configured with WDS and authenticate via a radius server. I notice that when i enable a user they are asked for a login but if they drop the connection or even shut the machine and go to log back in, they are NOT prompted for their login...

Have 1100 AP running 123-8.JEA1 code ssc client 4.1.2.Have LEAP and EAP-FAST configured on the AP, can authenticate with both methods when connecting to ACS, however if we break connection to ACS the local radius only authenticates with LEAP, EAP-FAS...