Wireless

I am interested in setting up a repeated wireless network using an 851w and an 1121. The documentation for the 1121 specifically discusses repeater mode. The 851w documentation doesn't specifiaclly talk about repeater mode but it does have the comman...

I have to survey a large hall for wireless coverage to support Voice. The internal structure does not provide support posts in one large area. The free standing area is ~180 x 100 feet. The ceiloing is 30 to 40 feet. How do I design redundant coverag...

Hi,We are trying to get the following working.We have a 4402 setup with a guest wlan. Layer 3 security is set to "web Policy" and "passthrough" - email input is unchecked.Under the securiy tab the web loginpage is set to "external (redirect to an ext...

Does the Aironet 1100 support IAPP?

Hello, I have a WLC using 3.2.116.21 Firmware and i have also 2 AP1010-E-K9 LAP. Both AP doesn't startup in the right way. The LEDs get red, then green, then off for a longer while with a lot of network traffic, then red again. After that the same pr...

HOWTO turn down the power on Cisco APs to reduce leakage?I'm trying to reduce the wireless leakage for a client, to somewhat prevent neighbors from 'seeing' the networks.I tried turning down the power levels, with no change in signal strength. I'm us...

We have a person that is hearing impared and would like to know if there are any amplified phones or amplifiers that we could buy for a 7960 phone.

Does anyone have recomendations for the density for AP's for use with WCS location? If I use the 3 AP's required for location triangulation in an area (300x200 feet) (with omni antennas) I get great wireless coverage throughout the area, but I get lo...

Is the WCS software necessary to manage a single 4402 WLC or is it just additional bells and whistles?Thanks - RV

I am running a number of AP1131AG access points that are showing transmit discards in the millions each day on the dot11G radio.all of these AP's are configured to use WPA/PSK and TKIP. All are running IOS 12.3(8)JEA.I'm puzzled by this as I also hav...

I currently have a class C network configured on my guest controller. I need to change to a class B to expand my range of IP's for DHCP.

I have 15 wireless laptops and 3 AP's, will i have to point 5 laptops to 1 AP or will they load balance themselves if I configure them all with the same details apart from static ip's any advice appreciated