Wireless

HelloWe have several 4404 controllers that each support 100 antennas.When I follow the documentation for using multiple ap-manager interfaces (our controllers have 2 fibers to one switch and 2 to another one) it says that I have to create 3 additiona...

we have two 7920's and seen that we could not get them to authenticate to AP though both ssid and the encryptions on both the 7920 & AP were correct.both phones could not authenticate and all settings were correct.it wasn't until we reset the phones ...

Hi allI have a 3200 MAR sitting on my desk right now and quite a headache: I would like to make an LWAPP antenna use the MAR router and another WiMC configured as a universal workgroup bridge and yet I have to make everything work together. I can mak...

I am working on a system to provide 500 lightweight access points, my issue is that each one of these access points needs to be powered and i am assuming POE as my primary option which leads to the 3750 switch, which i understand now have the WiSM mo...

Hi,We have:6 1130AG - 12.3(8)one ssidall 1130s are on the same vlanencryption mode wep mandatoryDo we need WDS to allow IBM thinkpad to roam freely between 1130s?Thanks in advance.

Could anyone tell me about the fips kits and its use?Wen i used config tool for NAC and AP this kit comes as option to choose.Thanksswamy

Hi,i'm trying out an 887w router but can't for the life of me figure out how to get the wireless running 802.11b. Before you ask why its so i can get PDAs connected. thanks in advance Charlie

I am trying to upgrade to version 4 on my 2006 LWAPP controller.I am trying download AIR-WLC2006-K9-4-0-206-0.aesto the controller.It APPEARS to download fine but I get these two messages after the download completes:"TFTP Failure while storing in fl...

Hi,i have a AIR-AP1230B-E-K9 running 12.3(8)JA2. when one of my clients who has not configured any hostname on his laptop connects to the AP using the inbuilt wireless card, it can be seen that the clients hostname (in the association list of the use...

I am attempting to configure a 1231G to use PEAP Authentication. I am using Windows 2003 Server running IAS as my RADIUS Server. The AP has been configured and is communicating with the IAS Server, but all of the authentication attempts are rejected ...

Hi,A have the following scenario:5 vlans configured on my AP, 3 of them use PEAP to authenticate users (not computers), I'm using ACS 3.3.3 connected to my Active Directory.The thing is, How can I filter access from one SSID to another if I am using ...

SSID is not being set to be "hidden" for the WAP in our office. I want the SSID to be hidden and not visible as we do want to control the access from being stolen by the contractors in our office. Please suggest how to have the SSID hidden. We can't ...

I am kind of lost on this:If I am using LEAP as authentication mechanism, am I automatically using 802.1x? On my Windows XP, I look onto the "Aironet Client Utility" I see no information on 802.1x there.I have configuration of access points handy her...

I have a problem whereby a particular wireless client is choosing to associate with the root bridge rather than with a nearer non-root AP which has a much stronger signal. As a result, the client is experiencing dropouts due to the poor signal to the...