Wireless

I know that there should be antennas installed on the APs, but i have 24 APs to configure with a basic config, another team shall do the rest of the configuration in remote. Now i tought to disable the radio interface (no power anymore on the antenna...

I'm a beginner with wireless and, even more so, the WLC. (I'm using an WLC module in a 2851 ISR). I have a couple general questions regarding the WLCM:1) I will be deploying five LAPs off of the WLCM in one floor of one building. Is it true I will no...

Hi,I am using WCS 4.0 with 3 WLC's and have noticed that sometimes, even though I make changes to the WLC's using WCS, I sometimes go back to the WLC's the next day and parts of the config seem to have reverted.For instance, I have some WLAN's that I...

Hello,We can't seem to remote desktop to machines on our wireless network. Whenever we do, whether on the wireless or wired network, you are booted from the system within 2 minutes. We are using a Wireless LAN Controller and 2 access points. We are...

I am trying to get an AP1231G in WGB mode to talk to an AP1231G in AP mode. Trunking works to the AP. The WGP associates with AP. I am assuming that workgroup-bridge client-vlan 10 effectively puts the ethernet port on the WGB on to VLAN 10. Do VLANs...

Please provide link to Cisco's Wireless Control System's online demo.

hello experts!!!i'm trying to register a 1500 lap with the airespace 4101.. (is that even possible without the WCS?) but i am unable to get an ip address. i issued a debug command and found out that the lap is talking with the controller. but it is g...

Hi,we have a WLAN implementation of several AP's in a shopfloor area, and we were having some troubles. Has I red about overlapping rules, I went to the problematic areas and I could see in one location over 5 even 6 ap's. I asked the vendor that imp...

Hello, I am having trouble setting up windows workgroup over the wireless connection.All computers over the wireless connection can see each other but can't ping or access shared folder (network path not found)however the wirless connected pc's ...

Hi Members,Any news on a Cisco 5GHz Bridge (such as Aironet 1400 or equivalent) that is certified for use in the UK (IR 2007).Aparrently we can go up to 4W EIRP with IR2007 on 5GHz bridging, much better than 2.4GHz allowed power.I don't think I can u...

? want to use ACS to verify the (management) login to the WISMs. Does anyone know if this is possible. I can only find related ducumentation about WISM/ACS for wireless clients and not for the management loginin to the console/telnet/explorerGoen

I have an access point with a 100' low loss cable (CiscoAIR-CAB100ULL)connected to an Cisco AIR-ANT2506 5.2dB Gain Omni antenna. I can stand right next to the antenna and I see only a 1bar signal strength using Windows Zero Config tool. It seems o...

I have 3 - 1230 APs running 12.3(JA)2 that will not stop recycling. I've tried using the mode button to restore to factory defaults, but so far have been unsuccessful. Any ideas?