Wireless

Hi,on the aironet access points there is a feature: PSPF - Publicly Secure Packet Forwarding. This feature blocks inter client communication. Is there a similare feature available for the WLC airespace products?RegardsJoerg

Hi,I currently deploy a Wireless Unified Infrastructure based on Airespace Technology.I provided a diagram in enclosure.I want to use the eap-peap authentication, based on Windows Logon/Password.My Wireless Client will use an Intel Wireless Adapter (...

Does anyone know the expected packet loss for broadcast packets in a wireless network?

Hi,Am currently having a problem with the new Nokia E-Series phones and I-Mates/IPaqs aswell where I try to connect to a WPA2, 802.1x, with CiscoSecure ACS and a WiSM, but keep getting prompted for username and password every 5 seconds (which doesnt ...

I have been looking for information on best practices/configuration examples on how to cluster two WiSMs in either one 6509 chassis, or one WiSM in one 6509, and the other in a separate 6509. THe 6509s are connected via HSRP and both are located at t...

We have 3 AIR-1232AG AP's setup in a controller-less enviornment that operate flawlessly with every wireless device we have with the exeption of one:Dell Wireless 1490 Dual Band WLAN Mini-Card running driver version 4.10.40 (the latest driver).After ...

Can anyone explain or refer a link about "Excluded Clients". I always see some clients are excluded with exclude reason "Identity Theft". What does this mean? How and in what situation does controller exclude a client? I could not find explanations o...

I'm using AP1000 and AP1200 series APs and am trying to configure Cisco Network Registrar to support DHCP option 43/60 dialog using NRCMD.. Thus far without too much success, has anybody done this?

Two 1100's are setup as a bridge, both connected to a 1100 running as a root-AP.A problem occurs when a client leaves the area where the root-AP is and goes to one of the areas where a bridge-AP is providing connectivity:no traffic is bridged. (Worka...

when we plug our wlc 2000 into our switch, we get lots of input and crc errors, this happens when we plug into into any switch, we have tried other switches but the same happens, any ideas ?cheers

Hi guys,I have a Cisco 4402-25 controller and 16 APs 1010. The WLAN is working fine. Can I add one AP as wireless repeator to get associate to AP1010? What model of AP it should be?Thanks,yytellmey

Hello,today I've one subnet with one 1232AG running IOS 12.3(8)JEA and one Apple Airport Extreme. Both are configured as follows :- Same channel (tested with different channel)- WEP 40bits. Open authentication for 1232AG- Hidden network- Just enough ...

I recently deployed a 4404 with WCS and want to block a MAC address from connecting to our wireless because of Deauth floods. We have around 40 APs. I am thinking it should be done through a template, but not sure. Can anyone lead me to right documen...

Hey,Yesterday i've encounterd a problem with a wireless network on the site. It's a network with 1 AP1200 (8JA2 firmware) and 2 1200 (8JA2 firmware) configured as WGB. For security settings we've used WPA PSK, AES CCMP and ACL.The network was running...