Wireless

I actived Management Frame Protection in WLSE with 1131 and ios 12.3(8)JA.when any wds find error with Management Frame Protection, do anynithing that reset all (with blue screen) intel centrino with intel wireless card 2200 at the same time.The next...

How do i change the IP address of my AP 1200 access point through console mode ?i am able to plug in my console cable to see the bootup but i cannot go into config mode to make changes to my configuration.I need to change the IP address because i wan...

In my wireless domain, I'll have a WDS, with 40+ AP as infra client, and 50+ workgroup bridges as client to the infra AP .My question :1) Only need to enable workgroup bridge on the client, right??2) Do I need any root bridge ??Thanks.

Can anyone point to some documentation on cisco.com that explains the difference between a WLSE 1130 and 1130-19. When I do a show version will it display WLSE 1130 or WLSE 1130-19?

I have upgraded WLSE to version 2.13.After upgrading, "Unable to verify MFP configuration","MFP Timebase Invalid (bad SNTP), Device was not reachable via SNMP" these messages are logging so many on WLSE fault status. What are these mean and How to so...

Hi all,I do a lot of wireless rollouts most recently using Aironet 1130 AP's. I've been getting reports of intermittent connectivity - but nothing consistent, i.e for a while it works fine in one area, then doesn't, then does again. I've done all the...

Hello - I have recently configured my 1231 AP (12.3.8JA) to perform authentication using EAP and WPA. I configured my Cisco ADU using a CB21AG card to do EAP-FAST and WPA with auto provisioning enabled. I also followed the Cisco config guide 100%. Th...

Hello --I'm having a problem where I can associate to an AP at my office no problem; however, when I take the AP to a customer's site it cannot associate to the AP, and at times my client has a hard time finding the SSID. If the SSID is found, my cli...

Sorry, if already asked...I try to config Wireless on Cisco 878...I want that switch ports be in one VLAN with Wireless port... and Wireless client be in one ip subnet with LAN clients...I use following instructionshttp://www.cisco.com/en/US/products...

I am looking at implementing building to building wireless using Cisco 1310 bridges. This would be a backup link between the 2 buildings. The primary link is 3 T-1's. There are about 250 users connecting back here for application and internet. I am a...

Hello,I configured my WLSE to check if my AP (AP1231 and AP1131) are SNMP reachable once every ten minutes. I want to have an fault only when SNMP reachability is down for 3 consecutive polling cycles = if an AP is down for 20minActually, I get a fau...

Does Cisco have a Path Calculation Tool for the 1200 /1300 series. I have the older tool, but it doesn't include 5.8 GHz or the newer products

As per setup B .The Wirless laptops are installed with AppGate client software.If I need to connect to the wirless network, there is AppGate Icon in the desktop of the Laptop.when I click a new window opens asking for 3 login details. Ie.. Open Conne...

Hello forum,We have just deployed WLC and WCS with couple of lightweight AP.We decide to employ MAC filtering to restrict wireless client.We noticed a SERIOUS problem, once we removed a mac address from the WCS and apply to controllers, Wireless clie...