Wireless

I have a customer looking for the most secure way to use his symbol scanners with his 1200 access points. Will the Cisco access points support the Kerberos functionality on the Symbols Palm based scanners.

We're running a pilot of the new Airespace stuff, and we just got the Location Server. I've got it configured and on the network, I've got it recognized by the WCS, and I've got it synchronized with our WLAN Controller and the Network Designs....And ...

What is the difference between WEP Mandatory with MIC and PPK, and Cipher TKIP + WEP128? Does the TKIP + WEP128 provide the same security as WEP Mandatory with MIC and PPK on Cisco AP?Juris

Is possible to configure this WLAN??I have configured one of the APs as the RADIUS Server and the EAP-FAST on 2 APs.The tests with one client are correct.Now I have to put one repeater, because there is no possibilty to connect to the wired LAN and I...

Hi, we have a Linksys WRT54G,(which we use for both LAN, but wireless enabled obviously) and i need to implement a wireless solution for the ground floor of my office. Can anyone recommend cisco wireless equipment that will suit my purpose(including ...

Hi,Can someone clarify for me how this works in a WPA-PSK scenario:If I configure WPA key management/authentication with TKIP cipher suite I dont explicitly need to enter a WEP key for encryption. Are the WEP encryption keys derived from the shared P...

I want to configure wlccp authentication on 12.3(4) or 12.3(7) but the AP doesn't accept the command wlccp authentication like the 11xx and 12xx series ap does.Any ideas?

I can't update the firmware on a AIR-AP1230A-A-K9 wireless acces point via http (or tftp). It reports "error:the software upgrade was interrupted and was not able to be completed". The file I'm trying to use is c1200-k9w7-tar.123-7.JA1.tar and curren...

Can anyone enlighten me on this question.When using Power injector to power up the AP, what will happen to the person if he were to cut the ethernet cable when there is power being transmit over the cable?

The WLSE uses the account [email protected], so our smtp server rejects all sending mail attemps. How can I change it to casuser@domain for the smtp server to permit it?

I get the following errors on all of the Wireless LAN controllers I have configured:Thu Oct 27 14:08:41 2005 [ERROR] dhcp_proxy.c 2897: Received a packet from ourselves, network loop! Thu Oct 27 14:08:26 2005 [ERROR] dhcp_support.c 357: dhcp_bind(): ...

I'm putting together a design and want to know if it is possible to use two AP1200s as bridges with the non-root bridge being mobile and allowing client connections whilst not connected to the root bridge. Secondly can I set up leap authentication us...

I have completed a site survey using the Aironet AP 350. I am now considering implementing the Airspace 1000 AP and their switch solution. Can the survey results be used with some degree of confidence to determine number and placement of these new AP...

Hiwe get alerts when there are rouge aps or ad hoc neterks. Problem is when the ssid is not broadcasted, in the wlse there is just /x/X os something like that instead of a ssid.when i get an email from the wlse and the ssid is seen then its correct:S...