Wireless

Hi,When I issue a show int dot11 command I don't see crc errors and others but using the web based tool I see a lot of crc errors, header crc etc. I would like to know if the web based management tool is a reliable tool? I have already cleaned the lo...

Hi,I have got two aironet 1100 series access points. They work fine expect I wanted the wireless users to pickup a dhcp address rather than giving them a static address. My DHCP server is on a windows 2003 server and I want the access point to relay ...

To All: I am looking for any documentation about the 3200 Series Wireless as to what the maximum number of concurrent wireless connections are per interface. I have not been able to find this information anywhere and I have conflicting reports as to ...

Hi,I have a problem to package the Cisco Wireles Client to a msi file using Admin Studio.Managed to create a msi file, and installed the msi file is OK.But after unistalled the software and rebooted, its crashed the operating system with lsass.exe ap...

does anyone know why the following happens?i am sitting at my desk with a wireless laptop running a constant ping to the gateway. if i watch the client utility, it will periodically reassociate to a different access point. i am confused in that i am ...

does anyone know why the following happens?i am sitting at my desk with a wireless laptop running a constant ping to the gateway. if i watch the client utility, it will periodically reassociate to a different access point. i am confused in that i am ...

hello,I have the same issues on multiple access points (all cisco 1200s - in different sites) in which users cannot authenticate until they walk close to the AP. (a site survey was done before installation) - and I get good link quality from the user...

I just read an interesting document about the Cisco WLSE, Air Magnet Enterprise, Air Defense. Since Cisco partnered with Air Defense and Air Magnet stating that they soon too will be able to intergrate with WLSE. Is Cisco leaning towards a new produc...

For hot standby,Should the mac-address of the active AP be the radio interface mac or the ethernet interface mac ?http://www.cisco.com/en/US/products/hw/wireless/ps430/products_installation_and_configuration_guide_chapter09186a0080147d79.html

Can I use the ap 1200 dual band for two diffrent role, 2.4 Ghz for in-building and 5 Ghz for inter-building; if so, the 1200 can be an access point and a bridge in the same time

Hi. I have a 1220 that I need to reset to factory. mostly because I dont know what its IP address settings are on it. I tried to console in but dont have control, I can see stuff scroll by but it isnt accepting my keyboard input.It stops when it gets...

My main concern now with 802.11 is deploying wirless into critical systems environments. Does anyone know the real risks of denial of service against 802.11b and g, and the effects of flodding a 2.4Ghz range? I ask this because I have a few customers...

Hi ,i have one cisco Aironet 350 using Channel one connected to an outdoor OMNI antenna( 12 dbi) Mounted on a tower of 20 meter height and providing connectivity to multiple remote sites , i am planning to add another Cisco Aironet 350 in the same he...

Problem: When using the web GUI to manage an IOS access point such as the AP350, AP1100, or AP1200, and when using TACACS+ to authenticate the HTTP accesses, the access point will send numerous authentication requests to the TACACS+ server for each w...

i have a couple of cisco ap1100 aps running with cisco acs and wlse. when access points were running an older firmware, both b and g radios are able to connect and authenticate using the windows peap client. after firmware upgrade to anything later t...