Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 17 , 2026 through Tuesday August 31, 2026. Our experts Saikat Nandy and Prashanth Bargur Hanumantharayappa will be waiting to assist you and resol...
The wireless clients use PCMCIA card to associate to 1200 series APs (latest ios 12.3(2)JA). The Authentication is LEAP and whenever it gets closer to another AP the LEAP authentication starts again which means the client disassociates & (loses its c...
I have an implementation that requires me to point 4 Yagi antennas (two pair of building to building Bridges) and was wondering what would be the best way to align them and if there is an automated tool to do so. I know that the 1310 has an LED in th...
We use a Cisco 350 PCMCIA for network communication on cranes. Some cranes lose the network contact to the access point while driving or staying in bad points of a hall, because of a too weak signal and/or signal overlays. This happens about one or t...
Bear with me, I need to set the scene.....We use catalyst 3550's where we have 3 VLANs. Port 1 is set in trunk mode and is used to connect to our WAN and is on Vlan 3. Vlans 4 and 5 are then used to seperate a secure and not-so secure lan.Now, we are...
Is it possible to configure 1200 AP to act as a DHCP relay? I need the AP to act as a DHCP client to a LAN based DHCP server but also forward DHCP requests received from the wireless interface so that clients may be assigned DHCP addresses. Anyone ab...
Hi. I'd like to trunk several vlans thru my 1400 bridge. I'd also like working QoS, as one of the vlans carries VoIP. I have a C3550 switch at each end. Do I have to:A. Create multiple SSID, assign one to each .1q ID, and have the bridges associate t...
I have been trying to set up a Compaq Tablet Pc, inbuilt wireless with Tablet XP client, to connect to an AP1200, however I have encountered two major problems.1) We use Dynamic WEP encryption on the AP's at the moment, however I can't find an option...
Hi Everyone,My organization is currently expanding, and we would like to connect two remote offices wirelessly. This venture will be outsourced; however, realizing that I have never worked with a wireless setup I would like to know what sort of infor...
As said on the title, is WGB350 compatible with WPA ?Thanks
I'm trying to connect to my AP1200 via http with no luck. I run a debug ip http transactions and get the following message when attempting to connect to the access point via http:HTTP: Out of linesI did a search on TAC and didn't find any documentati...
Does anyone have a date on when ACU 1.3 will be available on the website?We need to get the logon using machine credentials working and it looks like they may finally have this fixed in the 1.3 version.
Is a new release of the wgb352 will support wpa ?
I have a location where I am using a WGB350 going to an ATA186 then into a standard 2500 series telephone.Everyday the WGB will stop replying to pings, snmp requests, etc. It almost seems like it has lost power or connection. This will go on for hour...
My aironet350 connection is not stable if connected to LAN and even a single notebook using s cross-cable to the injector. Speed of eth. has made matching.Signal strength is 37%, sig.quality is 90%. The trend of unstable is, connect (reply if pinged)...
snmp-server view iso iso includedsnmp-server community comm_ro view iso ROsnmp-server community comm_rw view iso RWDoes the view iso create a weak spot in the security of the wireless network since hackers know the view exists on all AP's? If the snm...
