Wireless

I want to implement broadcast rotation key for WEP in the AP1200 with spectralink phone. Looks this feature only supports for EAP or LEAP enabled wireless device. The spectralink phone have a menu "rotation secret"(Secret > WEP > Rotation Secret). Is...

We have an application where we will be connecting two buildings using wireless. The far-end will have approximately 3-4 computers attached the network. Should I use a 350 bridge at the near-end and a 350 workgroup bridge at the far-end with a hub to...

2 BR350's OS version: 12.04Antenna: Yagi antennasGoal: Pass traffic between 2 buildings within the same subnet and access the bridges.I can pass traffic between the building fine but I cannot access the bridges after they associate. If I shutdown one...

We need to deploy a WLAN to provide DATA/VOIP to 100 people (Hotel Rooms), administrative facilities, etc.The distance radius is 200 mtsWe appreciate recommendations about it. Switchs, hub, access pont, etc.

Dear Sir or Madame,2 LAN of mine need to be connected. The distance should be less than 1 km (0.6 mile). I have plan to do bridging (IP Based) between them. Do Cisco provide any product that can do WIRELESS UNLICENSED 2.4GHz BRIDGING for outdoor inst...

Does anybody know how fast I can move with a vehicle on a campus in a 802.11g WLAN to get good datatransfers? Auth. ist LEAP or PEAP. Client might be 802.11b or g. Client should be installed on a vehicle. Is there a difference in speed between 802.11...

Anybody have implemented a wireless access implementation on a moving train or vehicle which has a predetermined path ? If yes, or if you have heard of any stories, please share some ideas. Does the Mobile Access Router work only with CDMA networks ?...

I am experiencing the following problem : I may access a WLAN with a 350 adapter but not with a 340. I have upgraded the firmware of the 340 to the latest version, the card is recognized by the ACU but the ACU states the card is not associated wherea...

I'm using 2 units Cisco br350 bridge to established wireless LAN to LAN connection.But on one of my bridge,I'm receving a lot of outside traffic such as multicast from,how do I block this kind multicast from associating with my bridge?,I'm afraid it ...

I can access most sites on the internet however, one site I used on a regular basis requires that cookies be set on my desktop or laptop. Since I have changed to a wireless network I am unable to access this site. Any thoughts, or suggestions?

I'm new to wireless and I have been doing a ton of reading.It appears to me that if I am authenticating my clients with LEAP and CCKM and then I add WLSE/WDS to manage my APs, my LEAP/CCKM clients will automatically begin doing Layer 2 Fast Reassocia...

What is the difference between Cisco's CCKM key management and WPA key managememt? I've read that CCKM is required for Cisco's proprietary Fast Reassociation feature, but that aside, is CCKM just Cisco's propriatary version of WPA key management? If ...

I'm currently setting up a multiple SSID wireless network in my office, I wanted to keep one SSID as Guest-mode, and one for internal user. each will connect to different VLAN.The problem is, whenever i have both SSID setup inside the AP, all i could...

I had no other devices associated besides my laptop.I did a 100+ meg download and noticed I was getting about 750-850KB per sec = approx 6mbs. In my a/b/g client card I unchecked the 2.4 - 11M seeting. So I was hoping to see the stated 22 Mbs through...