Wireless

I have 16 Ap 340 with 11.07 software and 1 Ap 1100 with 12.02 software in one building,All Ap 340 loss connection about 5 seconds to ethernet backbond and sometimes must be hard booting to connection agains.But the Ap 1100 have stable connection all ...

I have a BR350 with about 50 wireless clients linked with wireless PCI Adoptors. Both are CISCO devices. Lately i have been experiencing a lot of disconnects, especially at peak periods. Disconnects occurs radomly, however the clients that get into t...

hello,i have a problem with my card, i have it on a Dell 5100 (laptop) first:The card does not auto fall back when the range is far, it always stays connected at 11mbps, so that makes the range so weak. i have tried every possible configuration, but ...

I set up my Linksys wireless AP to be a CLIENT to AP 350. Both operates in the same channel. In the Event Log of AP350, I noticed both devices show several attempts to associates/Dissassociates. Does a difference in transmit power in both devices cau...

I tried to set up my LAN with a Linksys wireless b router but it is not producing a signal strong enough to reach a back office (best I get is 30%, usually 12-17%)There are walls (brick and glass) in the LOS. The linksys booster actually lowered the ...

I am planning to install the Aironet 1200 series product in my office. I need to determine how to size my system. What is the number of PC's supported by each AP? I will be running 802.11a.

Hi all,My question:Can I use the BR340 bridge (root bridge) and one AP350 (nonroot)to connect two LAN segments?

Since the OIDs 1.3.6.1.4.1.522... do not work with 1100 APs does anybody know what OIDs will give me # of associated clients on a 1100 AP?ThanksBen

I have several air-pci352 cards used with a 1200 AP. I was wondering if the air-lmc350 module(contained on the pci card) can be replaced to support 802.11g. We are upgrading the 1200AP to 802.11g when available.

I have 2 sites set up using MS IAS 2003 RADIUS server and Cisco 1230 APs. Both site that I have configured have MS DCs local and both sites perform USER and HOST based authentication. I have attempted to set up a third site, but this site is unique b...

Hello I setup an AP with 3 VLANs VLAN1=native, VLAN2=VoIP, VLAN3=Data. VLAN2and3 are working greate however the native VLAN which the AP resides I can not ping or web browse to the AP. I can use a cross over cable to make a connection. The native VLA...

I am trying to migrate to WPA but cannot find a download for ACU 6.2. In the IOS 12.2(13)JA software configuration guide, chapter 10, it states that a client adapter's minimum WPA requirements are ACU 6.2, firmware 5.30.13, driver 8.4 (1.2 install wi...

I used to connect different Antenna type with the AP 350 , now the 350 is out of sales and 1100 comes only with integrated antenna . any idea ?

I have an Aironet 340 wireless bridge, and I would really like to implement 802.1x authentication. While the 340 Access Points have upgrades to the IOS, the bridges do not. The latest firmware I've been able to find is 8.8. Any plans to release an IO...

We are a private school with 68 AP1200s and 3 AP350s deployed. We are a Novel shop with no NT or Windows servers. We also do not have the funds in out current budget to buy a Cisco ACS. I want to configure my APs to only allow specific MAC addresses ...