Wireless

Hi folksI must admit it - I am new to Wlan technology - and have bought an cheap (non cisco) WLAN router with an build 10/100mbps switch. I am of course a little worried about the security issues when activating such a unit in my homeoffice. To raise...

Does anybody know if you can use a third party (Senao) mini pci radio in the Cisco 1200s? Thanks

Members,Any suggestions as to which is the best WLAN management application to use for AP 1200s?Our WLAN Network is small at the moment but could grow a lot bigger.I would like to try Cisco Wireless LAN solution Engine, but unfortunately they do not ...

Hi,To test the security of my wireless network, iam trying to sniff the traffic using a 340 Cisco client pcmcia card.However, if i do not associate to the AP and even though i can see the SSID using Netstumbler, i do not sniff any traffic (using ethe...

hi I have a big installation with about 70 offices with aps and in the hq there is acs and a wlse. can i use wds withs PEAP also or just leap? does the rough ap detection also work with peap? on an intel centrino config i saw that just within leap. w...

Hi!I have to build a public Internet access WLAN. Everything is fine, but I'm not sure which antennas should I use. I'll use 1230's AP's, the 2.2 dBi rubber ducks are enough? Should I use a sector antenna? Or a big omni? Thank you!

Can anybody tell me whether there are any know issues with connecting an Airenot 350 bridge, to a 10MB/HD Hub ?I have one end of the link connecting to a Cat 2950G Swicth, with the ethernet port set to 100MB/FD and was wondering whether this setup wo...

I'm attempting to setup a 1200 AP with 12.2(13)JA1 to locally authenticate WDS, but to have LEAP clients authenticate back to the ACS Server. I first get client auth working to the ACS server, then add the WDS config. At this point WDS registers corr...

Now the Cisco IOS being available for AP's which one is better for the AP's?Thanks.

Hello, I have configured my AP with 3 VLANs (VLAN1=Native, VLAN4=Prod, VLAN5=Guest). The bvi1 int has an ip address of 172.16.0.81. however when I tried to connect to the AP via webbrowser or try to ping the ap (172.16.0.81) from it will loose connec...

I am running WLSE ver 2.5 with 1200 series access points, IOS ver 12.2(13)JA. I have the WLSE set to monitor associated clients and continue to recieve the fault AP is in Overloaded state (4294967295 associated clients. This only happens with a few A...

Hi,I was curious if the PEAP users of the Cisco forum (MS or Cisco PEAP) could state their login process, the amount of time it takes to authenticate, and if the error logs below are normal.I have set up both the MS and Cisco versions and the Cisco i...

We have an installation with approx 18 access points in a fairly small warehouse. The Cisco 1200 AP’s are running firmware version 12.01 T1.We have 3 VLAN’s at this facility and the cisco switches are doing trunking while the AP’s are doing 802.1Q ta...

I'm going to be setting up Cisco 1220's in a warehouse. I was wondering if there was a "rule of thumb" to use. We always use 100mw for power and 11Mbps. Previous warehouses, we've gone by the 50,000 sq ft rule, and we've had no problems. Is there any...