Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
I am testing a wireless layout with multiple VLANS in a test lab sandbox. I am trying to run 3 VLANS across a 1200 AP. Lets say VLAN 300 (10.50.0)is 40 bit WEP, VLAN 400 (10.50.1)is open, VLAN 900(10.50.2) is 128 bit WEP. VLAN 400 would be the native...
I have looked everywhere that I know to look (Cisco search, Google search, Cisco Software Selector, etc.), and cannot find the "AP1200-Cisco-IOS-Upgrade-Image-v1.img" file. I am starting to feel a little on the stupid side, because I suspect that it ...
I need a hand held device that comply with Cisco APs and its features .
Hello all,Building A: Access-Point 1230 B with Version 12.2(11)JA.Building B: WGB352C with Firmware Release 8.84.All works fine - means I think the configs are OK.(authentication open - 128Bit WEP nothing else)But (mostly) overnight the connection ge...
Greetings,I may have an RF interference issue. I do not have access to a spectrum analyzer... However, I have a AP that recently started dropping signal.I have replaced the radio already. When I am in close proximity of the antenna, I have excellent ...
hello i noticed that every time i use the cisco AP350 ((50mW) 2.4G 11Mbps) i have a headache :-((did any one notice the same problem !
Hi,if you install Cisco PEAP supplicant , the MS Supplicant with MSCHAPv2 support will disabled and only Cisco PEAP-GTC is available.Is there any possibility to have both versions available at the same time , so i can select which PEAP method I`d lik...
While implementing The Cisco Wireless Security Suite across an 802.11b (2 350 Bridges)link, I have to ask a question.I used to use 4 X 128 bit keys for just the WEP part (WEP screen has 4 places to set the keys).On the Radio>advanced Screen, you have...
HelloWe need to run a multicast app over wireless network.Who has some design guide or good paper on this? Any precaution we need to take care?thanks
I'm looking for the integration between ipass and BBSM server 5.2 guide or any information related to the setup. Thanks in advanced.
Does someone has configured a Navisradius LEAP server with AP 350?
These are the setup that I have: BBSM---Switch----AP----Wireless ClientAfter wireless client authenticated, if I let it idle without any activity ( meaning not accessing any web site/application), How long will it timeout the connection or it will ne...
I have a BBSM appliance (BBSM 5.2 Build 2.00) with all the service packs up to AccessCodesPatch.exe (Patch 5220).I am trying to transfer and then install patches 5223, 5230, 5232, 5233, and 5239. However, I get the following error message after brows...
I have read a paper that indicates NDIS 5 support is mandatory for adaptors that will be used for Hot Spot access. I don't believe the PCM352 has this - but appears to work in UK HotSpots I have evaluated.Latest wizard, 1.1, says it is installing NDI...
I am having trouble hardcoding ip address, works fine when leaving as dhcp, when i hardcode the bvi1 interface I wont be able to access it any more. I've tried this via web and command line. I need to know what i am missing.
