Wireless

I downloaded the newly released Windows Intall Wizard bundled with the latest ACU(6.0), Driver(3.5),Firmware(5.02.19), ACM(2.0).It installed properly and all worked well, and I like the ACM. However, the new ACU 6.0 caused a conflict with the Windows...

Received NULL MAC address as DESTINATION from source [ax340]000103e2f6ac on port "fec0"My Aironet LOGS are full of messages of this kind but everything seems to work fine. I do not exectly understand what do they mean (null mac destination address ?!...

Upon powerup there is no problem getting DHCP through my AIR-PCM35x: PC Card (PCMCIA); however, upon resumption from hibernation after about one hour the address has vanished. The card is still associated to the AP350. Have tried both re-starting v...

I have two AP 350 connected to a Catalyst 2950 at VLAN 3.This is the problem... if one user is working with his notebook (connected to AP 1) and starts walking to the other office so AP 2 would have to take control of the connection... how does Catal...

I've been trying to figure out the need for configuring the radio on a 350 AP with a unique IP other than it's ethernet IP? Doc says it's required for Standby mode or advanced configurations. Anyone have examples? Just don't see it.J.

Can the AIR-ANT3549 be used outdoors? At two different locations on the Cisco web site the AIR-ANT3549 antenna is described differently.One site says 8.5 dBi gain and you can use it outdoors:http://www.cisco.com/en/US/products/hw/wireless/ps469/pro...

Hi,I read about the AP1200 power utilizationonly 11a module = 8Wonly 11b module = 6W11a &11b module= 11wThe new 3550-24 PWR units data sheet does mention it provides 15W per port.The older 3500-24 PWR units data sheet does not have nay per port r...

Hi I want to understand how can i use the Carrier test result one the diagnodtic page of the aironet web interface for knowing which frequency is used or notthanks

I want to build a wireless lan with a radius autentification.nb : In fact, the use of this network would be made available by using prepaid cards, managed in a prepaid plateforme.Can i have some information?Setup radius ?

Have there been any issues identified with running Citrix applications over wireless? Have there been any studies done or lab results for this?

Hello,I am trying to configure a Radius authentication for an administrator logging on an AP1200 via HTTP. On the Cisco Secure ACS server I can see that the authentication was successful and with a trace I can see also the 'Radius Pass' answer coming...

How does the AP and end device know what speed to synchronize to? If the end device is transmitting at 60mW and the AP is 100mW who decides the conversation speed

We presently have many 1200 AP's installed throughout the factory. We have them mounted on columns approximately 12-14 feet off the ground and we are not having any problems with this. I have read that they should be mounted higher(maybe 25ft). ...

I know in theory this stuff all works together, but let me ask the question.My customer has Compaq EVO Laptops with the Compaq W200 wLAN module attached. They have bought ACS3.1 and AP1200s, and want to run PEAP authenticating with their Windows AD e...