Wireless

Cannot even connect via hyperterminal with required settings. Plugging in with ethernet doesn't do anything either except I get a blinking light on the switch. Never any light on the device.

I have been running couple of 350 bridges for about a year now. My firmware is at 11.23T. I am looking for information, hopefully a step by step, to enable the highest level of encryption / security that I can.I am running these in bridge mode betwee...

We started a video conference from a wireless workstation - a Cisco 350 client associated with a Cisco 350 Access Point.We successfully transmitted video and audio from the wireless to the other station on a different ip network, but we were unable t...

Is it possible to connect a AIR-LMC352 to an AIR-ANT3549 and if so what part or manuf. cable would you use to conenct the MMCX on the card to the RP-TNC connector on the antenna?My hope is to use this to communicate back to a 350 Series bridge in AP ...

Hi everyoneWe are looking at the possible creation of a "video only" network for the transport of our clients H.323 videoconferencing traffic throughout our community. Does anyone have any experience transporting H.323 video over wireless networks? A...

I have one Br350 set up as a 'Root Bridge' connected to LAN A core network and the other as a 'Non-Root Bridge w/Clients' connected to LAN B remote LAN, only SSID is configured .The non-root bridge at LAN B connected to DECRepeater 90TS(confirm good ...

my cisco 350 AP cannot associate with Symbol wireless cards. I already tried checking the Non Aironet part in the config for AP.

If i am having a 1200 ap from aironet ,can i use this ap with a client adapter which is of different make?(talkin about .11a standard)

I have installed last week eight AP-350 with some PC to equiped Cisco PCMCIA Card wireless.All it worked in order.Today customer called me to say that some PC can't connect through AP to network.What it can be ?What can I do to troubleshotting ?Thank...

Hi,I've got a question regarding how the AP works with session keys and LEAP authentication. Assume we have two PC client (PC_A and PC_B) with a Aironet CARD. They use both the LEAP authentication method and they are both well authenticated. AP has g...

Hi, Need to connect two LAN in one bulding 10 floors apart without installing any outside antenas. LAN (a) is located diagnoly to LAN(b). There is no, kind of, direct see throu places. Cat 5 cabeling will not work, lots of interference, plus building...

We're running Cisco LEAP enabled wireless clients on NT. Our Helpdesk would like to remote control these machines. Problem is: The HelpDesk administrators need Administrator privileges. They need to log in as themselves...remotely.When they do a "clo...

Is the aironet 350 bridge can function as an access point with the 350 access point firmware? And what is the reverse situation ?thx in advance anybodies response.

We have implemented a single 350 AP with Cisco ACS 2.6. The problem is that the clients are able to associate and logon through the radius server, but never receive an ip address. The clients are W2K and XP. Any thoughts on what the problem might be ...

Hello,every now and then (i.e. approx. 1-2 times per week) I have the case that the Cisco 350 WLAN card driver (I verified this on an iPAQ 3660 and a Casio E200 PocketPC suddenly decides to henceforth no more connect to (i.e. "associate with") our Ci...