Wireless

I am running version 11.21 on the AP 340 and 4.25.30/8.2.3 on the 350 client (win 2K). When looking at the adapter I see the IP address but cannot ping the IP address of the AP ethernet interface. The client is associated with AP340When looking at th...

Hello,I have two questions about Aironet 1200:- Are the filtering functionnalities the same as on Aironet 350? Does it allow to do filtering on destination MAC/IP address?- Cisco Aironet 1200 is able to both communicate with 802.11 a and .11 b termin...

I have 3 points X, Y and Z. Y is the cental point equiped with one bridge 340 and 12dbi omni antenna, the others sites have one bridge 340 and Yagi 13.5 dbi antennas each of them. They are configured with 11 Mbps speed. From X to Y is 1,8 kms and Y t...

Can anybody tell me, what is the "process gain" in a point-to-point link using BR350?.

WLAN FULL DUPLEX ARCHITECTURE ?As per my knowledge, WLAN are half duplex, but I have read since 2 weeks ago that we can build a full duplex WLAN if we have an access point that have the capability to handle 2 PCMCIA cards wich one are dedicated to se...

In researching the Cisco 802.11a products, I have seen the mention of the Aironet 1200 series which features an access point for thoroughput up to 54megabits per second for users within a building. Does Cisco offer an 802.11a bridge yet for intra bui...

While attempting a firmware upgrade on a 340 series wireless bridge, the bridge stopped responding. The status indicator LED is permanenntly red while the network indicator blinks amber. Console does not respond. Does anyone know of way to fix this?T...

Can anyone point me to some docs as to why with 802.11b you get greater distances with lower throughput. Is it because of transmit power?Newbie to wireless

When using the Bridge Outdoor Calculation Utility from Cisco i notice the cable drop down menu only includes the old STD type cables. Now Cisco have EOL'd the STD and 75ft cable, replaced with the LL cables, AIR-CABxxxLL-R products how does the calcu...

Hi, We have some Cisco 350 access points. Is it possible to make them work properly with Linksys WAP11 (Version 2.2)units? Some more details:-I have the Cisco set in "Root access point" mode and the WAP11 set in "Client access point" mode.I have done...

We have aironet 1200 APs. We use 11.42T firmwareIn the following configuration, we don' t have radio link:AP/root <------ Site Survey ClientHas anybody idea about this situation......The Antennas are good because it works in the AP/root <----- Repeat...

Currently : Using Static WEP Goal: Provide technology that is both moderately simple to implement and more secure than Static WEP.I have all Cisco APs. 20 Cisco LAN adapters using LEAP dynamic WEP. I will add 10 hand held devices plus 300 laptops usi...

Hallo,I have the following problem :I try to connect an iPAQ 3870 (with Pocket PC2002) and an Aironet PC4800 PCCard to our WLAN (AP4800 with FW V7.66).I use the actual driver 2.20.05 from your download page .But I got no association.Using the same PC...

I am having problem on setting up the repeater part

I understand that there is a provision to provide an ip addr, subnet mask, default gateway and static routes in a 350 wireless bridge..But are these options provided for routing between it's ports or are they only for ip connectivity to the bridge???...