Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

I have a customer looking to deploy a WLAN. His users are distributed over 3 VLANs. He would like to have his users be able to roam throughout the WLAN, and still retain their VLAN assignments.We thought we could do this via dynamic VLAN ports, but...

Just trying to see what kinds of ditances people are using these links at, as well as how high they have placed their antennas in order to achieve that distance? I think a small discrition of the equipment used would be helpful as well. We could us...

jcomca by Community Member
  • 1831 Views
  • 4 replies
  • 0 Helpful votes

Hello,I am running BGP on my Cisco7204 router. I have a network of 8292 nodes. the gateway for all my nodes is the router mentioned above. I connect to an ISP with another AS. I too have an AS number. I want the request send by nodes in my network as...

Gentles all,I am planning to connect a lecture hall in a university with wireless devices. The lecture hall will seat approximately 400 people (ostensibly all will have laptops). I have been told that the average wireless LAN device can only suppor...

bsalahor by Community Member
  • 1511 Views
  • 3 replies
  • 0 Helpful votes

Hi, I am tring to understand what type of link I will get with WT2710 at one end and WT2755 at the other end. I can read that it provides 22.2Mbps down and 18Mbps up. Then it describes it has a shared bandwidth downstream and that it uses frequency...

Would it be worth it to set up an ISP based on IEEE 802.11 b, WLAN NIC's and the Access point connected to some kind of broad band connection e.g *dsl T1 etc..And to give rental to your customers of the NIC's...?Could some one give me a list of produ...

aolionaird by Community Member
  • 1233 Views
  • 1 replies
  • 0 Helpful votes

We are planning to deply a ~30 mile link point to point from crowded area of City to Province.We have conducted a site survey inlcluding the "Line Of SIght", we perfectly have good "Line of Sight" considering the height and earth's curve. Can someone...

jay.jimenez by Community Member
  • 1056 Views
  • 0 replies
  • 0 Helpful votes

If I'm reading the product literature right, the only equipment you can put at the customer premise is a 2600 or 3600 with a WT-2755 multipoint subscriber network module to participate in a WT27xx WLAN. That's prohibitively expensive when you are tr...

ecbanks by Community Member
  • 1401 Views
  • 2 replies
  • 0 Helpful votes

i'm wondering if it would be possible to do a wlan an a distance of about 10 miles interconnecting users with a single pcmia card without connecting the users to internet ??as i live in france is there a special norm i must respect ??Regards

ripper by Community Member
  • 1379 Views
  • 2 replies
  • 0 Helpful votes

I have been researching all material regarding the WT-2700 equipment and can not find enough information on specification and deployment factors.I have a customer who has a three buildings which they would like to run point-to-multipoint. The main b...

shane-cross by Community Member
  • 1586 Views
  • 4 replies
  • 0 Helpful votes

I have heard a lot of talk about Wireless Security. And have at least a working knowledge of the two possible solutions, VPN and EAP. However, how to choose the best possible solution? VPN is expensive and still leaves me vulnerable to Impersonation ...

dsware by Community Member
  • 1400 Views
  • 2 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card