Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
Hello. I have trouble configuring mDNS for AirPrint services on EWC.What i have:Fully fuctioning 9120 AP with EWC controller on it, software version of EWC is 17.6.1b. Connected to trunk port on switch. Printer resides in different VLAN from WLAN cli...
Found this particular question online. Pasted it on the lower part of the body. Can anyone explain to me why letter C, passive client, is not the correct answer here? it should be based on this link. https://www.cisco.com/c/en/us/td/docs/wireless/con...
Hi, Can anyone help my issue. APs can not join mobility express controller. Attached are the boot log, etc.
Hello.I've got AIR-AP1815W-E-KE. I read the official Cisco manuals and guides about configuration and what puzzles me is that the GUI shown in the pictures is completely different than on my device.Here is an example:GUI from "AP 1815 Wall Plate Depl...
Resolved! Guest not getting login page
I have gone through the documentation on setting up Guest wireless. We want to have the user enter a username and password.We are using Aironet 2802I access points with Mobility Express - version 8.10.151.0I have configured the guest network.Under WL...
Is there a freeware SW to view installed access points ?
Does anyone know the technical difference between the AIR-MOD-POE and the AIR-MOD-SPOE. They both appear, separately, in different versions of the documentation for the Aironet 1800s module. When I configure an 1800s in a CCW estimate, currently, o...
Hi Experts, We have a SDA environment, the Sponsored Guest Portal (Login Page) is created and pushed by DNAC to ISE. The behavior we are seeing is every time our wireless guests connect to the network, they complete the sponsor flow and also see the ...
What is best practice to wire a Cat5e cable (4 pairs) with an RJ45 at one end, and a LSA+ at the other, which only uses 2 pairs?How does one best "wire" or isolate the unused 2 pairs?Many thanks
Were looking to upgrade from 3.9 to 3.10. Can you complete the upgrade using the CLI?
Dear All one of our customers asks that we have to generate a heat map for the access point. need suggestion that which software will do heatmap ??
Hello,I need to update this old AP, but I cannot find nothing on cisco.com suopport/download page.Could someone show me where to download latest firmware version for it ?Full model is AIR-AP1242AG-E-K9many thanks, bye!
Hello,I recently deployed an EWC running on two 9130 APs. I am trying to add a Cisco 1815W AP for the deployment. I was able to get everything up and running, but the LAN interfaces do not appear to be working.They are 'enabled' in the AP config:I cr...
How to check ssh-rsa key configured in UCS ?
Hi All, Can some one please share the Procedure to add New AP in the Cisco 5508 Wireless Controller (Step by step Procedure). What is the normal latency we can expect for the Wireless connectivity.? Is the below latency is normal? Ping from AP to 8.8...
