Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 17 , 2026 through Tuesday August 31, 2026. Our experts Saikat Nandy and Prashanth Bargur Hanumantharayappa will be waiting to assist you and resol...
Hallo,What is the correlation between 'VLAN Support' and OfficeExtend AP in WLC? When one is enabled, the other is disabled but I can't find a proper documentation on the reason behind it.I'll appreciate a response.
i have a Mobility Express deployment and have just added an 1810w in local mode, how do I enable the 3 local switch ports including Poe?
Hello,Did anyone try to use or configure AP1815W LAN ports in Mobility Express deployment? Is it possible?
The situation for the client is: HA 10.24.110.249WLC1; 10.24.110.251; WLC2 10.24.110.252; I'm observing. The Ip . 251 is how stanby ?I guues the correct stanby wiil be ip .252, I suppose. why the ip 251 is how stanby ?Additionally, I can see that th...
Hi, i have Mobility Express with Aironet 1852i as primary controller (software version 8.10.171.0). Can i add some Catalyst 9115AX as subordinate? Thanks
Hi team, user facing frequent wifi disconnection.Upon capturing the debug logs in the Access point found the below logs.Please confirm whether the issue is with authentication or the driver. Post the below mentioned message user goes in to the auth p...
Hi i am trying to start to configure a C9120AXI-EWC Controller out of the box. The WAP has powered up & i have used the initial setup dialog to configure an IP address/default route & login creds. However, according to this guide Cisco Embedded Wirel...
I have setup a Guest WLAN and profile policy using its own VLAN with DHCP from our firewall. This works fine when connected to our DELL switch stack with the port set trunk vlan 2 untagged (native) and vlan 50 tagged (guest wireless). In the EWC acce...
I have Cisco AP 1562 is lightweight connecting with Cisco AIR-ANT2513P4M connecting port A of AP to Port A of Antenna, How i checked that the antenna is connected properly and working fine, any command to check ?
We have IW6300, 1562, 3800 series APs currently connected to the AirOS WLC 3504 and were having AP licenses installed on the 3504 WLC and now wants to migrate this AP's to new Catalyst WLC 9800, but we haven't had DNA licenses procured earlier. Will ...
Hi,i am having problem on this set-up. i have made it work on other installation but i am having problem with last night's installation. clients are not getting ip address via external dhcp server. i have pointed the particular interface to the dhcp ...
Hello teamWhat is the current firmware version of Meraki AP and the MR 29.3 firmware is beta?Thanks
Hi there,Have we any integration possibility with Wireless Controller C1-AIR-CT5520-K9 + Access Points AIR-AP1832I-Z-K9 using Cisco Connected Mobile Experiences and Cisco Identity Services Engine?It would be nice any integration, but have all network...
[*09/13/2022 10:24:16.9919] CAPWAP State: Discovery[*09/13/2022 10:24:16.9998] Discovery Request sent to 255.255.255.255, discovery type UNKNOWN(0)[*09/13/2022 10:24:17.0031] Discovery Response from 192.168.215.110[*09/13/2022 10:24:20.2965] Discardi...
Hi,we have a bunch of C9800-40 controllers running IOS-XE 17.6.3. Yesterday, we discovered that from about 1.200 APs more than 50% were in monitor mode on the XOR radio. 2.4GHz coverage was very bad in some areas.On the FRA page in the GUI (Configura...
