Wireless

I need to replace my wireless network and I am replacing wireless network comprised of single point access points in a cluster with Cisco AIR-AP1832I network. Can I setup the new network with the existing one still functional if I create a new Networ...

Curious if I could get some assistance with a few questions regarding using an Aironet as a WAP versus Bridge.  I need a bridged solution to connect to network at a different building a few hundred feet away.  I was planning on using something like a...

Over and over my coworker and I debate the whole "client has weaker Tx power than AP" topic. We have strived to turn our AP Tx power levels down to match our client's Tx power level -- 13dBm. However, in the back of my mind, is a concept I heard from...

Hi, I have academic experience in Cisco networking (no certification), and no industry experience either. I just joined a company as a Junior and have been given the following client requirements for a Wi Fi System to understand and submit a RFP (Req...

Hi,I have a number of Meraki MR33 APs, that when I assign a static IP address can't get to the Meraki dashboard, and I have tested another device in the same port, with the same IP Address etc and it can ping the dashboard. The AP is connecting into ...

Hi , Any one help me out to configure Cisco prime . we have 200 sites have Cisco router and switch . when I am trying to add one site google earth .kml file in cisco prime, it gives me errors ""details specified AP'xyzhostname' in placemark was not f...

Hi,Is it possible to get basic alarms for APs / WLC into PI syslog ?I want to use the external syslog server to sort out this information.It is also essential that we get AP hostname in the syslog message. I have tried test this out but I cant see th...

We had an AP a while back just stop working and started giving this constant loop of CAPWAP errors. We tried to do a factory reset by unplugging, holding the MODE button, and reconnecting power while holding the button until the light turned. This di...

I have installed a Cisco AIR-ANT2544V4M-R antenna and Cisco 3702e AP combination.  The AIR-ANT2544V4M-R antenna is suspended from a cross beam in the warehouse and is mounted with the globe facing downward to the floor.  The Cisco 3702e AP shows on-l...

Hi, I have an WLC 8540 running 8.5.140 code (HA pair) that has approximately 1800 AP's that is acting as an RF leader (auto) that is running the entire campus.  I want to do a PoC of a WLC 3540 (HA pair) running 8.10.121.0 with 9120AXI AP's in one of...

Hello, I have two instances of CMX running 10.6.2-72 on VM's (Non-HA).  Before this, they were both running 10.5 via HA but I had to break the HA due to issues.  Now, I would like to re-enable HA but both boxes are standalone primary servers.  Is the...