Hello my friend. I have cisco wlc 2504 and 8 ap 2802i . Recently I ran into a problem. Different clients periodically lose connection (can't pass traffic). I've been searching the forum for similar problems and found these two CSCve57121 and CSCvc670...
If I look at the Alarm on the Alarm Summary it will allow only the first 1000 rows to be exported. How can all the alarm lines, over 2000, be exported? I believe a report from the "Report Launch Pad" will allow it but i can not find a report specific...
Hi all Hoping someone can help. Our WLC sits on a subnet 192.168.5.0/24, the wireless dhcp address pool in question is 192.168.10.0/24 and we are consistently running out of ip addresses. We would like to increase the pool to use the 192.168.11.x sub...
Hello, I would like to know if it is possible to show statistics about SFP Tx/Rx of the int Gi 4 on AP-1572EAC via cli mode? I already use the commands "sh inventory" or "sh peripheral sum", but no Tx/Rx value are shown. Thanks for your help, Regards...
When using a guest anchor setup with layer 3 (where external webauth is being used with an external radius server) it appears that although radius accounting works fine, the "acctinputoctets" and "acctoutputoctets" values are always zero (0) in both ...
Hi, Can somebody explain to me what happened to this AP with this crash log file Thank you very much
Hello, I have a production MSE server that is currently pointing to a Prime 2.2 box. I've installed a new Prime 3.3 box and would like to migrate the MSE over to the new 3.3 box. Can you point the MSE to the new and old server at the same time? ...
Hello, With regards to a wireless client sending multicast traffic to another wireless client within the same SSID/VLAN. Does multicast need to be enabled on the wired portion of the network as well (Controller management VLAN , AP VLANs, etc)? Mul...
H all, Does anyone know why the placement of the Cisco ISE Web Auth portal is located within the internal network for this design guide below? Is that the preferred security design? Figure 21-4. https://www.cisco.com/c/en/us/td/docs/solutions/En...
Currently have a pair of 5508 WLCs running 8.2.110.0 code with several AIR-CAP2702I-B-K9 APs. I need to expand in an adjacent space. Is there any technical reason to not start using 2802s?
Hello,Able to access console on the 3700 AP yet unable to find any commands that permit the assignment of a static IP and mask?
Hi all,I would like to ask you if there is any option how to stop TFTP transfer for WLC upgrade???Thanks for your inputs.Regards,Michal
Hi, I'm trying to configure IPv6 on Dynamic Interface in WLC 5508 version 8.2.151.0, but there is no IPv6 field configuration in the GUI, Controller > Interface. Only IPv4 configuration. (Image below). I've enabled the IPv6 on the 5508. For the...
Hi, We have an issue where mobile devices (mostly Apple iPhones and iPads running a variety of OS versions) are getting de-authenticated from our guest wi-fi solution (using ForeScout) after around 5 minutes of inactivity on the lock screen. These de...
HI， I have two wireless controller,one WLC version is 7.0.116.0,another one version is 7.2.110.0.I want to upgrade WLC5508 from 7.0.116.0 and 7.2.110.0 to 8.3.130 .So,could you tell me whether there are some Precautions?Thanks.
