HiLogon to leaf from apic. below is what I can see. its linux mode. How to change it into Cisco mode? Thanks
Forum Posts
Hi, I have two different tenants with a VRF on each one and a tag assigned at the VRF level. All the prefixes generated in a particular VRF are tagged. When the prefixes originated in one VRF are learned by the other VRF, the tag is overwritten. Is i...
When traffic enters leaf switch, what tables aci system will check in order to reach certain destinations? below are several tables. If the below is not that correct, can you provide your suggestions? ThanksMAC Address Table:When a packet arrives, t...
Hi experts,I'm currently working on the MCP protocol and use the CLI command "show mcp int info interface all" to display related statistics. -------------------------show mcp int info interface allInterface: Ethernet1/9 ...Interface MCP enabl...
Resolved! Match rule for route tag
Hi,I want to apply a route-map that matches prefixes coming in over a L3out with a particular route tag in OSPF, however the match rules only allow BGP communities or prefixes. Is this not possible on ACI?Thanks.
Resolved! Packet transferring in aci fabric
Hi Please see below picture. That is diagrame of aci packet routing. Anyone can explain the relation between the numbers in green box and blue box? Thanks
Hi folks. I've been looking at adding a CIMC for an ACI APIC to TACACS / ISE. It's currently running on 4.1(3f) so does support TACACS+ (supported since 4.1(3b)). The ISE server already has several CIMC devices authenticating against it (although the...
Dear members, we have a ACI Cluster which is currently running with 5.2(1) version. we have a VA as mentioned below Below 2 CVE has been fixed in the previously recommended version (5.2(8) and 15.2(8h) Cisco Application Policy Infrastructure Controll...
Hello,We're unable to connect APIC-M4 to leaf's (N9K-C93180YC-FX3) uplink ports using CVR-QSFP-SFP10G adapter. We've tried converting port to downlink but it shows "out of service" status in CLI and invalid status in APIC GUI.We're really short on ac...
Hi everyone. Please assist here. What are the things we need to include in a UAT as test cases for Cisco ACI? It will be like one of the service provider is having their ACI environment for other customers to host their own application and servers i...
Resolved! DHCP Relay in BD with Multiple subnets
I have a BD which has two subnets. The BD is mapped to Two EPGs each mapped to different subnets. I am configuring a DHCP relay that provides an IP Address from the primary subnet even if the host is connected to second EPG with a non-primary subnet ...
Hello Guys, Can you plz help me to know if SCP protocol on APIC controller is globally configured? If yes, where to see it? If no, then how to configure?
Hi Everyone,Maybe this topic was somewhere here already but I cannot find any information so I am hoping that you will help me some way.I have vCenter integrated with APIC and I check everything, have IP etc.... but one thing which I cannot establish...
We have been working to reduce our network footprint in our on premise datacenter. Because of the shrinking data center we have decided to replace our ACI environment with Nexus and FEXs without ACI. All of the existing ACI equipment is on end-of-sup...
Hi GuysI received a RMA from Cisco to replace an APIC Server (M2 Model). After unboxing the server and completing the setup with sucessfully. I encountered an issue with the OOB interfaces. The interfaces are not working and remain in a down status e...
