I have reviewed the Events and Audit Logs and in the Events tab I found a lot of records like this : uni/usersessext/delsession-oKX0GAPrTV6IJZzVIhOEaQ==Createduni/usersessext/actsession-4j9PF3KyRViDkqcXR4Lf_w==Deleted I have more than 100 pages with ...
Hello All, I have a home lab and decided to add an ACI environment since I am studying for CCIE DC.Got APIC-M3 appliances, one spine, and two leaves.unfortunately, I did not know this caused an issue and did a dumb thing and installed ESXi on my APIC...
Hi Everyone, I am currently working on a small project in which i have to delete alot of unused static ports. Now as i was going about i was wondering how i would know which port is being used and which isnt.. so i figured out that i could moquery fv...
Hi everyone,We have some issues with our ACI connection between 2 POD. The 2 EPGs between 2 BD on the same VRF that are located between 2 POD can't access each other. BDVLANxxx: EPGVLANxxx : POD1 : DCBDVLANyyy : EPGVLANyyy : POD2 : DRCWe are using ...
@cisco aciHow do I check firmware version of leaf switch ssd
please help me to check the ssd log, I want to know the problem of the ssd lifetime, thanks!F3073: fltEqptFlashFlash-worn-out (90% lifetime)
Good Morning,I have a Cisco ACI in 5.2 version in my LAB with a customer tenant configured. I need make some changes in bridge domain configuration to configure subnet ip address and associate it to outside L3. The customer has 4.2 version and I´ve c...
Hello everyone, I'm trying to install Multi Domain Manager from the Cisco DC App Center: https://dcappcenter.cisco.com/multi-domain-manager.html but got an error after I upload the app on the APIC : Failed to install application Multi Domain Manager....
Hello Community, I created a small ACI Lab and finally I found an old APIC-M2.According to the BIOS, the TPM module is owned.However, if I start the installation of the APIC, the installation fails.As soon as I disable the TPM and install version 4.0...
Greetings, all,I have an endpoint that keeps going into a freeze state and I can't figure out what is going on and how to resolve it.The MAC address and IP addresses in question are physically assigned to the "IPROUTER2" host, but based on the EP Tra...
Hi experts, We have an issue reported by server team ,they observed some packet drops and delay in reaching the destination server (Tx drops on the tunnel interface) Source : 172.X.x.25Destination : 172.X.x.35 In this case how do we check from N...
Hi Trying to set up generic Syslog on MSO version 3.1(1g) and following document - https://www.cisco.com/c/en/us/td/docs/dcn/mso/3x/configuration/cisco-aci-multi-site-configuration-guide-311.pdf Screenshots on page 83 don't match the GUI on MSO. The...
Hi Experts , Do we configure QOS in ACL LEAF switches ?How do we check if QOS is configured on the leaf switch ? How do we check the running config for interface APIC GUI ?
Hi all and nice to meet you.I have some ask/doubt for my deployment where is necessary deploy a single couple of FW CheckPoint with one node active on site1 and node standby on site2 (this geocluster throught and dedicated BD layer 2 streched working...
We were in the middle of uploading the APIC Controller .iso file in prep to update to latest version and noticed on the node we were uploading the .iso file to repository got to 95% full and complaining. So we stopped the upload process. What actuall...
.jpg "VIP Advisor"){kind=icon}
