Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am trying to configure sticky on an ACE 4710 and don't understand what the netmask part of the sticky ip-netmask netmask address {source | destination | both } name command.Some examples use 255.255.255.255 and others use 255.255.255.0 but I ...
We did a faulty ACE30 module swap in a HA pair. Both the ACEs have stopped syncing since then. Below is the error message I see:FT Group ID: 1 My State:FSM_FT_STATE_ACTIVE Peer State:FSM_FT_STATE_STANDBY_CONFIG C...
i don't know why cu need this feature, he want stickiness based on source ip and source port. Does CSS 11500 support stickiness based on source IP and source port? or is there any other method t...
Hi,Is there a syslog message for a state-change for rservers, if so how could we enable this?e.g. when probe fails state changes to 'probe-failed'when all probes are successful state is 'operational'Thank youBilal
Hi,we have a configuration as follows:VIP/port1 -> rserver1/port11 | rserver2/port21VIP/port2 -> rserver1/port12 | rserver2/port22Users are connecting to an aplication via web browsers, some tags on the web page are available under VIP/port1, othe...
Hi Guys,Looking through the release notes for A5(2.1) I noticed that there are a number of open caveats which indicate that the bug has been fixed in a version that is not available as yet on CCO. Example:•CSCuc04894—The ACE reloads without generati...
We have deployed Cisco WAAS in our network. Most of the acceleration works great except one issue: MAPI accelerated sessions are quite less in number:MAPI: Global Statistics ----------------- Time Accelerator was started: ...
Ok, here the problem I´m having:Nexus 7000 (nx-os 5.2) connected to my WAEs and configured for only one of the VRFs.I want to add another one from the VRFs already configured on the Nexus to the WAAS (4.3). Is this possible? Does anyone have some exp...
Dear Gents,Attached is the current setup & configuration for both ACE & FWSM.we can ping the VIP from the user side, but we are not able to open the web application using the VIP.Appreciate your kind support to solve the issue when trying to open the...
Hi,When connecting to an IBM Websphere thru the ACE, the user gets a return URL with a port number which blocks communications since only port 80 is permitted.Ex: user goes to http://maximo.abc.comThe browser gets back the following url http://maximo...
Hi All,I'm working on a specific config and have an issue in the backup farm/fail-over/sorry server area.The customer wants the following:They have an existing serverfarm with X web servers, they want a single server to act as a reverse-proxy in fron...
Hi,is it possible to construct the L7 HTTP class-map expression to match all URLs except one?I have 1 correct url, for example: /correcturl.* and want to redirect requests to all other possible URLs to this one, without the need to list them all in "...
Hi All,I'm trying to determine where the config file is located on my WAVE-574 device. I recently had the device RMA'd (fault DIMM slot and console port) and i'm hoping to retain my previous config. The issue is that since the console port was inacce...
Dear MisterI need to pass FTP through ACE, but the is not functioning.The FTP is not functioning using VIP. It is a connection toward a NAT ip address. I have the next configuration:class-map match-all NAT2020-PRUEBA 2 match source-address 10.40.2...
