Cisco Catalyst Center

I am running 2.3.5.6.  I can't log into GUI with either Maglev or Admin profile.  I have access to the CICM and SSH.  Can anyone help me figure out what is going on?

I'm standing up a new pair of C9800-40 WLCs using Catalyst Center. So far so good. It seems to add all the settings when I provision the 9800 through Catalyst Center.There's a few settings that I can't seem to find a way to include when the 9800 is p...

Hey all, I have exhausted my google searches.   I am trying to manually add my WLC 5520 to my DNA Center deployment.  This has proven to be quite challenging to say the least.  I am at a point now to get the token and setup trustpoints from the DNAC ...

Hi, I have the responsibility of looking after a Cisco DNA  / Cisco Catalyst Center box, there is an update, can you tell me if it possible to rollback to the current version if the upgrade fails ?Installed version:2.3.5.6-70143 - Release 2.3.7.6-703...

Reason and Suggested ActionsInternal Error : NCIM12024: All information from the device could not be collected successfully or the inventory collection for this device has not yet started. It may be a temporary problem that will resolve automatically...

Hi Just a question. What is checked if I do something like this in velocity. if ($interface.interfaceType == "Physical") because if I will call @$interface.portMode == "access" then I see that only interfeaces where switchport mode access is configur...

Hello everyone,I struggle with how to delete a file which I've uploaded to the namespace config, with the api call "POST /dna/intent/api/v1/file/{nameSpace}" in Cisco DNA Center.Thats the file I've uploaded, to use to configure a device via an api ca...

Hello,On C9300L switch , I have on every port soure Template and Network-Policy configured. The network policy is to tag the phone in Voice VLAN. After restarting the switch I get the following error for every Port:Command rejected: Network Policy Pr...

Hi, I've received two CW9162i in Cisco DNA management mode and would like to convert it to Meraki mode. I've checked the configuration guide and was only able to find a way through WLC or Catalyst 9300 switch which I don't have.  https://www.cisco.co...