When go to device 360 for an AP and click the Intelligent Capture buttom, there is no data there. And there is a warning icon "gRPC link is not ready (shutdown)". From the WLC gui (Monitor - Intelligent Capture) I can see that the state is active.
Forum Posts
Resolved! DNAC Health Score Intermittent issue
Under DNAC Inventory, health score for all our devices, about 10 of them, are going on and off. they show 10 but after a while some of them show no health randomly, and then some of them change to 10 again and so on so forth. Ping to the devices seem...
CCNA study question. is enabling the device to allow user- or group-based access Authentication or Authorization?thanks
Dear Community, i want to integrate DaloRadius with a switch, i have troubles authenticating. and after I set up the radius there won't be any ping between the radius server and the switch, this is what i applied on the switch:radius-server host 11.1...
We have all of our devices safely snuggled into DNAC, provisioned and managed; however we have our ASR1000, and our 9400 series cores and distros plust all of our Access switches not appearing on the Assurance > Health page As you can see they show r...
Hello Gents, kindly can someone explain to me Lisp Pub/Sub and what its benefits rather than Lisp/BGP
I have a pair of FTD 3110 and a virtual FMC, not part of the fabric. I was wondering if it's worth adding it to DNAC. what can DNAC do with it? would DNAC push config change to the firewalls?
Hi all, Application visibility service, does not show any info on Cbar and NBar. when I provision, I get message that Application recognition service not installed go to software management. my issue is I don't have access to internet from the DNAC. ...
I have an unreachable device that I would like to delete from Inventory. I'm running DNA Center v1.2.8 (system 1.1.0.715). My attempts to remove the device from withing the application have failed. Maybe the solution resides in using an API call or s...
Dear Community,I have deployed DaloRadius which is free Radius server to a cisco switch now i can't login to the switch even from console,I tried to login with every user i made in my Radius server, but still it shows me: Authentication Failed. User...
Hello, i onboarded my switches with pnp nd everything worked fine. My Management VLAN is my onboarding vlan. I had to make some changes in my design network hierarchy so i deleted the devices an discovered them again and assigned them to the sites....
Hi, I have an intermittent problem where DNA Center seems to error out when provisioning templates to switches, the log says: Message: Unable to push the invalid CLI to the device 192.0.2.2 using protocol ssh2. Invalid CLI - 'terminal width 0'. C...
Hello, Is it possible to use DNA Assurance to know Top N application/Ports/End points consuming the traffic ?
Resolved! Cannot see application health in DNAC
Hi,We are trying to get application health to be seen in DNAC. We currently see only usage and throughput, it's missing other parameters to calculate it.Considering our employees are mostly using wifi it would make sense to configure netflow on WLC. ...
Resolved! DNA Center Full Backup Size
Hi, I have a DNAC Server gen 2, configuration with 2 SDA Fabric Site. I managed about 215 Devices (included Fusion Router, Border Switch, Intermediary Switch, Edge Switch, WLC and AP). I doing a full backup but size is so big (~ 213 GB), backup progr...
