HiWhen updating device images (router or switch) via the DNA-C GUI there is an option to mark "Initiate Flash Cleanup after Activation".The question is, if there is way to tell DNA-C to perform the same action when updating devices via the API?If the...
Forum Posts
We have an SDA environment with an embedded Cisco WLC we are trying to configure dynamic vlan assignement using the ISE for wireless users : 1 SSID with Dot1x access and the VLAN assignement using the ISE. Is it possible to do that. @DNAC @EmbeddedWL...
Hi all, Does anyone have any specifics on how to configure a Linux server for DNA to do backups to? We have a fresh RHEL v9 installed with the rsyncd utility running but we keep getting the following message on DNA... Remote server is not supported: ...
Resolved! SD-Access Intermediate Node
Hi AllI was going through Cisco SD-Access and I wonder weather we must acquire Intermediate node or our core switch i.e catalyst 9500 can act as Intermediate node. Thanks for your answer.
when provisioning WLAN APs via DNA-Center the country code is not set correctly. Is there an automation available to use the geolocation data information from the assigned site? for example AP is assigned to France, and when provisioning the AP to th...
Hi, We are using DNA Center to provision the wireless over to several sites starting with plug and play of access points and then pushing the desired config via DNA Center provisioning. One thing that I have not been able to solve yet, is how to r...
Hello i have an issue that my laptop on LAN-VN cant get dhcp from fusionso the dhcp server on fusion router where it connects to border-edge then border to Edge node fusion to border are using overlay trunk with bgp then from border to edge using IS-...
Can anyone give me a clue? IOS is available to select in the list, but when I select it as Golden, it says "Tagging" and the cursor spins but nothing happens. The ios is verified and there is an empty star in the Golden Image column.
Hi All,I facing some issue to set DNAC to send email to my mail address:At first I thought the issue could be at the server end but looking at the error message closely, it seems the issue is at the client end (DNAC). see error message below:It looks...
I want to create a DNAC velocity template where I can go through the ports of each switch in the stack and IF the interface contains the command "switchport access vlan 1" or "switchport access vlan 1" or "switchport access vlan 3", issue the stateme...
I'm trying to upgrade our DNAC appliance but when trying to go through the System Update i'm getting the error "System update failed during INSTALL_PRE_HOOKS. Applying pre system update hooks failed for node 100.64.16.5". Anyone got any ideas or seen...
Is it possible to run DNA center on other than DNA appliance for example on Hyper-V or ESXi.
I have two DNA Cetners and on one when I create a discovery I have the option to select the Netconf port but on the other is says "No credentials to display". Even on the one where it is there I cannot find where I configured it. Anyone know where I ...
Hi, I am having problem creating SGT in DNAC. It was working previously. DNAC and ISE integration status is ok. I get the errors (see attached screenshot) when creating SGT in DNAC. com.cisco.cpm.nsf.api.exceptions.NSFEntitySaveFailed:org.hibernate....
Hi All, Does anyone knows if DNA advantage license is required on Cat9K switches for virutal networking? or the essential license
