HiI have a Cisco SG300 Switch which I'd like to monitor using CheckMK or really any software.Checkmk successfully received the following things:- Anything about network interfaces- Uptime- System Information- Port Status- POE WattageHowever I'm still...
I am trying to setup a NSS3000 Cisco NAS device. No matter how i set it up (Raid 0,1,5 jbod) and no matter how the share is configured, i cannot see it in windows!Im hoping a firmware upgrade (or downgrade) will get it working but i cannot find any...
Hello All,I recently acquired a Cisco 2504 wireless controller however the previous owner dose not recall the username or password for this unit. Is there a way to reset it back to the factory default username and password? thank you in advance Dann...
I am trying to update a Cisco Catalyt 1300 switch - via Web GUI this works perfectly. Unfortunately I have customers where I only have a Linux Jumphost and no access to the Web GUI because it is disabled. So port forwarding via SSH is also not an opt...
Hello All, while looking for some information on Cisco Websites on how to mount/place CBS250 8 port switches I found lot's of information but almost none of them referes explicitely to these switches. On the data sheet this switche is defined as Desk...
has anyone configured a cbs350 switch stack to work with Microsoft NLB in multicast modeI have found the the cbs350 does not allow adding the multicast mac address (complains illegal) to the mac address-table and does not allow adding it as a static...
I have an older aruba switch with a sfp port and a multimode fiber connected to it.then I use a networkcable to the CB250.on the other end of the fiber is a CB350.when I connect the fiber cable from aruba to CB250 I get link up, but no internet.on th...
Hello, I am working with a CBS350 series switch that is up to date on the latest firmware. I am trying to enable the CBD probe to check into the dashboard, which was also recently updated to the latest version. I run through all the steps as provided...
Hello, I recently got a CBW 140AC for my homelab, its main purpose was to move all IoT devices to their own network; incase one of them gets hacked. However, I managed to migrate everything to the new IoT Network except this darn HomePod Mini, the HU...
I am currently facing an issue with one of my ikev2 vpns. The issue is that some remote ips that are on the vpn are unreachable (these were working earlier) and giving send errors on phase 2 output when i try sending any traffic. On the phase 1 it sh...
This is related to a previous issue I posted here "titled issue-getting reply traffic back from our cbs 350 switches".I have three VLANs defined on our CBS350 switches and sub-interfaces configured on our router (PaloAlto firewall) with all policies ...
Greetings, I'm creating a system that requires a TAA(Trade Agreement Act)-compliant switch be used. I have a SG500X-48p, SN: DNI181602C0. How can I verify whether the device is TAA compliant? Thanks in advance for any responses.
The management function of 240ac Wifi accesspoints does periodic radius requests with a user named "cisco-probe". Part of "Active Fallback" radius mode.Currently these requests fail, and fill up my logs.Which password does this "cisco-probe" user hav...
I have tried multiple instructions on resetting this switch (Cisco 2960L-24PS-LL), but nothing I do works.I have held the MODE button while powering on the switch for various intervals (from 15 seconds all the way up to 2 minutes)I can access the con...