IP Telephony and Phones

Need to add just purchased license to add to SRST capacity

Hello guys. Today i installed UCCX with demo license. Am stuck in route point and cti ports registration process. They are in created in cucm but whith status of none normally they are registered with call manager... Immediate response will be highly...

Hi Community I have an issue where we have a no audio issue for Delayed offer calls going to an SCCP 7940 phone (issue is happening with 7940/7960 and 7925 phones). We know those models are old, but I wanted to know if there is a workarround for my ...

hi I have a xcoder to convert between g711/g729. in my test, a 7940 (sccp) and 8945(sip or sccp) in a region that only allows g729 the voip is a sip trunk that only accepts g711 if i call from 7940, the call is successful because is allocating the m...

Does any other Cisco phone model (other than 7811, 7821, 7841 and 7861) supports SIP IP Phone firmware 78xx.11-7-1-17 ? I want to know if we have any other models which uses this firmware version.

We have Attendant console 11.0 advanced. An operator created a personal Directory and added the contacts. We want these contacts to only show in the perosnal directory, but are somehow showing in the main directory as well. According to Cisco docs, t...

Hello all, I have this issue and was wandering does someone else got it? THE issue: After upgrade the Extension Mobility is not behaving normal as prior to the upgrade.  IN all the cases - user is logged on without proper confirmation of successful ...

Hello, Please help me to understand the below. SIP ( Cisco 7942) phone registered to CUCM. When dialing out, do you think the phone sends out an INVITE to CUCM or the CUCM starts composing one and sends out. How does the digit analysis happens here. ...

Ok, solution mode….   Scenario – I have a small site (2911 -> H.323 -> CUCM) where I have 4 x PSTN on FXO. Now, at the moment all outbound calls decided by dial peers which will hunt (dial-peer hunt) with preferences of 0/0/3, 0/0/2, 0/0/1 & 0/0/0 et...

Hi, I have ism-sre-300-k9 installed on 2901 router. Module status is failed. Reset, reload didn't help. When I try service-module ism0/0 session command, it asks username and password, but I don't know credential. Password reset failed. Router#servic...

Hi, I'm having problems trying to replicate the database on cisco ucs c220, the following message appears: " Thanks!

ISP refuse the call because the  Source port is showing as UDP 53194, this port need to be UDP 5060 in the router debug we can not see anything related to this port. Please assist on this

Good Morning - we are running CUCM 10.5.2 with 8831 conference phones.  We have been requested to add a speed dial with a couple of pauses and then a 6 digit code.  This works fine from a 7975 SCCP but not from the 8831 SIP as I believe this is sendi...

So, i'm not positive i'm in the right area but basically i'm just trying to figure out how i can programatically add and remove a DN from a line group. can anyone point me in the right direction? i use c# but if there's an API or something or even co...