IP Telephony and Phones

Hi Everyone,We have lots of numbers come in on our SIP, we are have problems with just one number that during busy periods (intermitant) generagtes a ISDN Code 57 and 403 Forbidden error in the logs, like all our numbers this points to a Cisco CCX sc...

Our cisco unity express (CUE version 3.2 )is not allowing us to add additional users and following message is coming up, is it something relating to licensing? Can we upgrade it to the latest version 7.xThanks,Asad Hanif

Hi,Recently upgraded to CCM9 but this problem existed since v7 (was hoping it would just go away).Answered incoming calls have to be put on hold due to one way audio (outbound from the consultant to customer, consultant cannot hear the customer). Onc...

HiI can't access translatorx.cisco.com anymore, is this application removed from Cisco?RegardsChristian

Hello,I have configured a Cisco 2901 router with VWIC3 card as VoIP gateway. But I'm having the following problem:When I throw calls from de IP network (with Asterisk PBX) to the PSTN network, and the call is rejected by the end user, the call end ne...

Hello,Have posted a lot lately hopefully have not worn out my welcome!  Everyone here is very helpful and it's most appreciated.  Last step in getting my CME configured is getting all the phones to ring on the second incoming call on my SIP trunk (an...

Hi,     There is a customer that is having "random" problems with FXO interfaces on a Cisco ISR 28XX, they claim that the interfaces start to get captured and cannot be release unless the do a "shut / no shut" in the port.    boot system flash c2800...

hello..i just to make sure, what kind of different between CCX and IP IVR? many documents say its same.. many thaks before

Not sure if I should be posting this in the UC migration but, we just Migrated from CUCMBE 5k (6.1) edition to CUCM 6k (9.1.2)The migration went well with the exception of 5 ATA 186 at our remote site. Our setup is this:PSTN----> Site1 with CUCM 9.1 ...

Hi all and Happy New Year.I am a home user and have signed up with sipgate for a free geographical number, all works fine on X-Lite Softphone. I have since purchased a Cisco 7940G IP Phone and cannot for the life of me get it set up. I cannot ping or...

DearsWe are using CUCM 9.1 with CUBE, PSTN connectvity is through SIP trunk. We can sucessfully dialout and dailin. On call tranfer caller listens to MOH and as soon as the forwarded call is picked, Call is disconnected.Find attached the debug. Kindl...

I have been working on getting FXS attached devices to be able to make calls (mostly faxing) from a remote site thru our corporate PRI. I have setup the GW in CUCM as H.323 and given it a CSS of "PSTNGateway_CSS" which contains my Internal_PT, VM_Pil...