IP Telephony and Phones

Hi i have 3 users sharing same extension( shared line) in CCM 4.1 , i want to know whether they can access common mail box. Because we can not create 3 subscriber in the unity for the single ext no. how to go give voice mail facility to the 3 users w...

I was wondering if there was a way to configure CME to beep in the phone when the person paging through to the other phones in the paging group being used.It will beep if the page is sent to an overhead speaker paging system, but not when paging thro...

HiWe have been given loads of 10 point license paks for CUCM BE 6.0.1 instead of a few 100 point paks. Is there a way to bulk register them on CCO or do we really have to enter all the details for each one ?

Hi, i have a callmanager 4.3(1) where i have registered a VG 224 using SCCP protocol. The customer wants that the analog phones that are managed by the VG have distinctive ringing when the call comes from the PSTN (off net) and the call come from a c...

CallManager 5.03 digit dialing in the system.I have DN 606 and 114. I have deleted DN 6060 and 1140 (there for test). Deleted them in the unassigned DN too.Even if I have no conflict, I have a 5 second delay when dialing those 2 DN. It is like the C...

Hello all,I got a call this morning from one of our users stating that they get a fast busy when they dial the voicemail system. I verified on my phone, and then checked in Cisco Unified CM Administration and I see that all 12 voicemail ports are un...

Here is my config... Can anyone see why this would not work. IOS is 12.4, SRST is 3.3

I am new to CCM. Try to create my own phone profile to open web access. Which directory should I upload the file to? I couldn't see any cfg file in the defalt directory for my current profile.How do I navigate TFTP server directory? Thanks

Hi ... I have recently deployed a number of ATA 186's and all appear to be working fine, except the speed dials. They have been configured on CM. But when you key * 1, you just get "the number you have dialled has not been recognised". All other "pre...

This is the configuration from ipipgw document:gatekeeperzone local GKVIA usa 10.16.8.24zone remote GK919 usa 10.16.8.146 1719 invia GKVIA outvia GKVIAzone prefix GK919 919*I understand outvia, if call send to 919*, it will send to the gw in the GKVI...

we can call and connect to 9-411 service but the voice prompts cannot hear us. although the 9-311 and 9-0 can hear us fine. this is only on one site in the cluster. Have you heard of this probelm and any idea where I might start looking to rectify th...

Hi all,I currently have two completely hardware seperate phone systems, both running cisco ccm 4.2(3) with a publisher & subscriber server, the "New" phone system I built was completely created from scratch, due to many techincal and hardware reasons...

I have a VOIP client. They are seeing a 11 second delay between the time they dial their number to the time they get the ring tone. This happens across the clients network, to and from.Our voice ports have no config on them, just the basics, no fine ...