MPLS

i have a tough case. for it, the client wanna know the 3945 isr routers and 7204 series can support the L2 mpls???if yes, both of these  2 devices can also support the following protocol standard: CCC、Martini、Kompella, as well as VPLS????thx & b.rgs

Dear all,We are using L3 VPN Hub and spoke topology with CE-PE protocol = EBGP. We have 12 spokes sites now we want to run OSPF over MPLS links by using GRE tunnels without IP Sec.If we use point to point GRE tunnels (in this case we have to make 12 ...

Hi All,        I have been faced with a challenge in the last three days yet unresolved.The issue has to do with Inter-AS Option3I hope with my explanation you can have a good picture of the topology which goes as follows:10 routers in total makes up...

Hi,We have a /28 on the outside and want to assign seperate IP addresses with NAT to seperate VRFS, for example:130.140.131.78 -> NAT -> vrf A -> 192.168.1.1130.140.131.79 -> NAT -> vrf B -> 192.168.1.1on so on and so forth....Is this possible ? I ha...

Hi,Kindly advice - does the WS-X6708-10G-3CXL - C6K 8 port 10 Gigabit Ethernet module with DFC3CXL (req. X2) line card support MPLSDo I have to put DFC3BXL instead of DFC3CXL....or is DFC3BXL similar to DFC3CXL?Reply to mgitonga@sevenseastech.com ple...

HiCould someone clarify this for me please. If I send a packet from a CE to PE with DSCP EF marked my understanding is by default the top 3 bits are copied to the MPLS EXP bits.So the packet now has a label(s) with EXP value 5 and an internal IP pack...

Hello,My LDP router id, OSPF router id and BGP router id is different, will it work to forward the traffic of customers or not?Thanks in Advance

Guys,I have read a few docs on it but seem more confused than I was at the beginning. This site (http://e-articles.info/e/a/title/Multiprotocol-Label-Switching-Virtual-Private-Network/) for instance says and I quote "If the payload is IP traffic, the...

I know the functionality of  "mpls ldp advertise-labels for access-list" command. I want to know what are pros and cons of having this feature enabled or disabled in the network. Is it good to have MPLS Unicast Forwarding application in the network b...

I have implemented 2x sites(SiteA+SiteB) SAN DS8100 storageasynchronous replication over IP/MPLS Layer2 with 35Mbps speed(SAN_A--FCIP_A---Router_A--IP/MPLS--Router_B--FCIP_B--SAN_B), When Icheck the connectivity I see timeouts, also I have adjusted t...

hi everyone,i'm issuing a problem with the Layer 2 ETH/VLAN to Frame relay interwroking.actually it works fine on the ETH/VLAN Side , the problem occure on the FR side where i notification msg while executing a CLI commande : PEconfig)#connect fr_iw ...

Can we have trunk between more than 2 CE over MPLS in short we are looking for the point to multipoint MPLS L2 VPN where more than 2 CE will share the common ethernet segment over MPLS  to share the vlan databaseLet me give more info @ solution which...