What is the best way to configure a load sharing policy from multiple CE "remotes" to two CE "hosts" in a MPLS network? Currently, all incoming traffic goes to only one host from the PE.
We have received a request to support multicast in a client vrf - I came across the following Multicast config guide (http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a00805a32b4.html)Are there any gotchas that I sh...
Hello,Has anyone here implemented "GRE function over MPLS"?Would it be possible to point to some links discussing advantages/disadvantages and some design aspects of the same?ThanksCheers,~sultan
I have a small setup as given below.CE1_LAN---PE1---PE2---CE---CE2_LANI can ping the CE interfaces from each CE and also from VRf from the PEs, but cannot ping the CE LAN routes, I have added the IPv4 address family and specifed the CE LAN routes.Did...
Our configurations require an outbound route-map from the PE to the route reflector to set some attributes (such as local preference or community). In the route-map configuration we have: route-map send-to-rr permit 10 match ip address prefix-list h...
Hi,I have a PE router running MPBGP which receives two default routes to the internet through an IPV4 BGP session. I need to import these routes in to a VRF and export them to different customer VRFs so that these VRFs are able to access Internet.I h...
Hi,I have a core routers which are mpls as well as ipv6 enabled . Now I want to give ipv6 vpn service to the customer.Is that possible ? any document on that will be appreciated.I have read the 6pe feature but that is talking about giving ipv6 servic...
Hi,We have a need to provide "GOLD" priority to a clients ethernet connections between our POPS(I have attached config that will hopefully achieve this over 2 PE's) - The client is also requesting that Citrix traffic be given the highest priority als...
l'm working on a 12410, i have a SIP 501, i want to confirm that the SIP is working correctly.tha status and Rate LED of the SIP 501 remain Yellow, and when starting uo the Card, il receive an error Message :GRPSPA-3-ERROR: slot 7: null TSM proc data...
Hello,I have a question regarding the redistribution process in MPLS network on the SAME PE router.I have PE-CE RIPv2, and in the MPLS is MP-BGPv4. Between MPLS Core and LAN Core is OSPF.I redistribute RIP to BGP on PE, so I have CE routes in the BGP...
Hi All,I have lab configured like the diagram.my problem is when i configure a tunnel interface on ce1 with tunnel source interface s1/0 which is connected to PE1 and tunnel destination is the ip address of Ce2 which is connected to PE2. OSPF is used...
Attempted to apply service-policy output MPLS-EGRESS to ATM Int:!class-map match-any GOLD match mpls experimental topmost 5 match ip precedence 5 class-map match-any BRONZE match mpls experimental topmost 3 match ip precedence 3 class-map match-any...
Hi, 1)I heard that control word is not mandatory in ethernet attached circuits in a VPWS ? Can anyone let me know the reason ? 2) Is there any equivalent concept of control word in IP pseudowire (eg.in the case of Kompella circuits , ATM on one side...
Hi,I have two questions:1. Can anyone put in plain words the differences between E-LSP and L-LSP and what would be a valid application of each?2. Is it correct that when poping labels the EXP value is not copied to a revealed label by default (as opp...
