Hi,
I'm wondering if Profile 10 (p2mp-te with static mapping in VRF) is supported in ASR9000 XR
I configured according to this link
http://www.cisco.com/c/en/us/support/docs/multiprotocol-label-switching-mpls/multiprotocol-label-switching-vpns-mpl...
We are possibly partnering with another service provider where we will act as the transport between their service and their customers.We have an established ASR 9000/920 MPLS network, and I regularly build E-Line/Tree/LAN services between customer si...
Clarifying the issue, the end user uses the application Cisco AnyConnect Secure Mobility Client and don’t works when connect it through HFC network, I mean CMTS, but when uses ADSL and GPON technology works properly.
I’m not sure if MPLS l2-vpn it’...
Hello guys,
I have a requriement to implement PE to PE encryption in my client's network.
It can be HW (using per line HW encryptor) or SW (solution) based.
I am first looking into the SW based solutions.
What are the possibilites Cisco offer here?...
Hello
We implement MPLS-TE with class-based tunnel selection in out network and face a problem with mpls mtu at master tunnel. All interfaces and MPLS tunnels have MTU greater than 1516, but master tunnel always has 1496.
sh run int tun1111interf...
Hey all, I need a definative answer on why the following is not working:ip prefix-list Management seq 5 192.168.0.0/16 le 32route-map Exp-Map permit 5 description Management Nets to Management Provider 1 match ip address prefix-list Management set e...
Hello Everyone,i ran the LDP on OSPF within BGP, both ospf and bgp connections were up. the loopback interfaces between two peers were also pingable each other. but LDP neighbor came never up. With Debug mpls ldp transport connection was followin...
Does someone know how to debug this error message please?%IPRT-3-RIB_LOOP: Resolution loop formed by routes in RIBThis error message spread everywhere inside my network.thanks!!
Hi,This is a well know issue that keepalives configured on tunnel interfaces in vrf brings it down. I did some wireshark capture on the link between Ts1 and tS2 but did not come up with any findings.I wanted to find out what happens internally in th...
Hi there,
I will need to config a p2p mpls layer2 vpn links (xconnect) between two Nexus 7700 PE routers. CE will connect to PE via ethernet.
The link needs to support dot1q vlan trunk.
Can someone share share some info or a working config exampl...
Dear Team,
when my BGP link flaps on MPLS primary and secondary with different service providers , the routing update changes only from spoke to HUB,
on the HUB side , the route is not refreshed and learning the route , even when clear ip bgp nei...
Hi
I have a use confusion between, L2 VPN, and L3 VPN.
I know little about how MPLS and normal VPN works.
1. what are the differences between L2 VPN and L3 VPN , are these L2 and L3 VPNs related to MPLS ?, 2. bcz when I typed l3 or l2 VNP on G...
