Network Management

I am experiencing an issue in LMS 3.2 where devices in the DCR, are being managed in RME, and cannot be discovered in DFM.  I have applied all known updates, Turned off auto-discovery, then re-started LMS.  Then re-enabled Auto Discovery.  No Change....

Hi All,Does anybody know if there is a way to disable SNMP traps being sent for specific HSRP groups?In my scenario, I have a number of routers that have multiple HSRP groups defined. Two HSRP groups from each router are in a INIT state because the s...

Hi, everyone that like that kind of stuff. I am ready to become an expert of TCL scripts, especially when back in college i used to do lots of C++, VB etc. This was 8, 9 years ago.. Anyway, i am just getting started but i need some help I need a scr...

I'm looking for OID for VPDN Session LimitClosest OID I came across is this - 1.3.6.1.4.1.9.10.51

Hi,we have some routers with poor bandwith, and lot of HighUtilizaton SYSLOG messages.I create new event set for them in DFM, I unchecked the HighUtilizaton message, but I still got the HighUtilization messages.What could be the problem? Thanks for y...

Hi im new to this forum and have read other forums to try to change my NAT setting to open but none of them seem to work, maybe because their whole network isnt set up like ours is.Heres what its like,2 xboxs (one wired, one wireless)3 laptops (one w...

What is the minimum IOS Version for Routers and Switches does CiscoWorks LMS 4.0 support? Or it supports all Versions of IOS? Can't find any documentation relating to that. Thank you.

What is the best practice for timezones on routers and switches?  Should I make them all the same, say EST?  Since this is where all the management servers reside or should they be set to where they are located?  Should I be using GMT/UTC time?Commen...

I have two  7206 routers that I can't get the configs from. I have double checked credentials. The failures show as:CM0151 PRIMARY RUNNING Config fetch failed for ber10 Cause: TELNET: Failed to establish TELNET connection to xxx.xxx.xxx.xxx - Cause: ...

Brand spanking new Cisco 3560E switch.Release notes for this switch state:++CNA CompatibilityCisco IOS Release 12.2(40)EX and later is only compatible with Cisco Network Assistant 5.0 and later.++I'm running 12.2(53)SE2.I'm able to log into the switc...

Hi,We are managing about 3000 devices via CiscoWorks. All devices have been added in CiscoWorks manually and automatically discovery is turned off.Problem: Mistakenly many devices have been added in CW multiple times with different IP Addresses. Plea...

Hi guys,our LMS server has proxy access to the internet but running a EoS/EoL hardware report results in:-No data available in the report. The problem could be any one of the following: 1. No EoS/EoL hardware data available in the LMS database for th...