Network Management

Hi all,i have a switch (WS-C3560-8PC) Cisco IOS Software, C3560 Software (C3560-IPBASEK9-M), Version 12.2(50)SE3, RELEASE SOFTWARE (fc1)where I get no values when asking the spanning tree mib (1.3.6.1.2.1.17.2).But this switch is configured like all ...

We recently upgraded to LMS 3.2 from 2.6, RME is reporting some devices as out of sync and details are partially successfull failing to fetch the vlan.dat. I've checked device credentials.Here is a a snapshot of the device details from one of the dev...

HiI have deleted a device from the DCR database . i still get alerts from DFM for that devicei have checked if there is device information in DFM device mangement too . there is no details about the devicePlease help

Hello,Is there a possibility to display ip devices in the CiscoWorks Topology view? We would also like to see the connected workstations.I don't think this is possible, but maybe someone has another idea. Maybe installing UTLite, does this work?(http...

unable to run check device credintial job. says to check cda.log:

I have a problem with Inventory Collection (inventory Collection Failed). I have 6 switches Cat6513 with (72033_rp-ADVENTERPRISE_WAN-VM).I increased a timeout snmp for 10 seg, but the problem persist.I attached a  IC_Server.log....and device ip is 10...

Hello,I was interested in checking out the QoS Policy Manager software but unfortunatley I don't have any servers that is not Windows 2003. QPM will work on Windows XP but CiscoWorks Common Services will not. Didn't know if anyone knows that there is...

Hello,When I launch an ipm job, it says source not responding like you can see in my screenshot. I have checked the IOS version and the snmp and ssh credentials are well configured. I have also made a show ipa sla application but I am not familiarise...

Hi there,due to a db-crash we had to reinit our HUM-DB.Unfortunately every HUM-configuration (poller/thresholds/reports) seem to be configuredin the HUM-DB.So we have to build the config from scratch.It is only possible to export templates.Are there ...

Currently, I install QPM with LMS3.1 and I have a problem with Cisco QPM. When I import 6509 VSS Switch from DCR to QPM then have a device could not be imported. IP address of the device is 10.160.1.130, the Device summary interface of QPM  displays ...

Hi all, I need to import a .my file downloaded from Cisco in order to monitor Digital Signage Manager notifications (snmp)1st .my file is ftp://ftp-sj.cisco.com/pub/mibs/v2/CISCO-DIGITAL-MEDIA-SYSTEMS-CAPABILITY.my and 2nd one is ftp://ftp-sj.cisco.c...