Network Management

Dear AllI have lms ver 3.2 with HUM running on it.I had created poller managment for all devices.in HUMIssue is that for some devices when i checked the polling reports its showing all reports.But in interface detail when i clicked on detail there no...

I wish to use SNMP to copy running-config files to and from several 6509's and a TFTP server.When I run SNMPwalk on a 6509 using the   CISCO-CONFIG-COPY-MIB it says there is no such object.....# snmpwalk -v2c -c <community> <device>  1.3.6.1.4.1.9.9....

Hi,I keep having problem collect inventory from 6506-E with Sup32.  To test one of them out, I deleted one 6506-E device from the DCR, manually added it back to DCR, manually added the credential.  Connectivity tests with SSHv2, SNMP RO community str...

Hello clarke,i m going to install LMS 3.2 and also a NAC 4.1.Any precaution or guidance that will affect LMS process or flow by NAC.Thanks

I am trying to restore an automatic backup taken last week from LMS 3.0.1 - win2K3 Standard Ed and want to restore it to the same box that has been re-imaged to LMS 3.2 - Win2K3 64 Ent EdEverything was going well - Common Services and Campus Manager ...

Hi, when I open Event Sets in DFM I don't see any of the event codes listed. Please advise.Thanks,Mark

I have a switch that only has all End Hosts with Last Seen timestamps of Feb 20. Some of the end hosts are still on the network, while others are not. I have one Major Acquistion every 12 hours, and one Minor Acquistion every two hours. My purge inte...

Hi, I have 329 devices in DFM that are "pending", I'm having trouble porgressing any more than that. Please advise.Thanks,Mark

HelloFor two physical servers to run CNR 7.x in backup mode, do I need 2 licenses or just one?I have single license, can install it on server #1.Server #2 requests license after installation and if server #1 is online, server #2 doesn't install the l...