Network Management

Hello Professionals,I'm having an PoE power provider issue from my Cisco 9200L switch but not sure it is hardware defect or one of bugs.So, here is my switch ver:Switch Ports Model SW Version SW Image Mode------ ----- ----- ---------- ---------- ----...

My case id # is 00150352 and the details are below:I Cannot complete the Networking Essentials course, offered via skill forall platform, the last chapter won't mark as complete. Same after I haveanswered every evaluation questions about to the cours...

Hi everyone,we have a couple of ASR1002-X with IOS-XE 16.9.2 used like a BNG/BRAS to terminate the PPPoE customer session.We do not find MIB/OID to collect single SNMP of single Vixx.xxx PPPoE interface, created from a Virtual Template.There is a con...

Hello Experts,i have a ASR 903 and i have problem with PBR , when i apply the route-map on the interface , traffic is not following next-hop in route-map policy, It work well on ASR 1002does PBR work on ASR 903 ? Please find below config template for...

What is the telnet port I should use in putty for the device connected to the following async port? #show line   Tty Line Typ     Tx/Rx    A Modem  Roty AccO AccI  Uses  Noise Overruns  Int  0/2/1   27 TTY   9600/9600  -    -      -    -    -     0  ...

We used to use Macro scripts for testing on a Cisco Catalyst 3850 switch.  Below is an example of the logwrites from the script we used.  I am currently trying to get the same routine to work on the Nexus 9000 switch and it has not been working so fa...

Hello, need help, i have cisco 3650 switch configured with vlan 10 and vlan20 wich is dhcp server also for that vlans, there is rogue dhcp server connected on that switch in vlan 20, how can i block dhcp offers from that rogue server with DHCP snoopi...

Hello everyone, I have cisco switch sf300-48p poe suddenly the ethernet ports LEDs don't blink when I connect an ethernet cable and I also can't access via console port. Can anyone help me?Thnx

We are looking to use the Rest API for adding configuration dynamically.  The routers in question are perimeter internet routers, and we would like to make sure that the source address can be restricted/locked down for security purposes.  The documen...

Hello everyone,recently we upgraded our CoreSwitches because they were EOL.Our old switches were Cisco Catlyst 4500.Is there a way to degrade them to normal switches? Thanks in advance! 

Our company is going to have to power down all the servers in our data center / computer room because of required electrical maintenance.  What steps should I take ahead of time to prepare for this, we have the below equipment Core sw, edge switches,...

HiI need to schedule in python script automation backup for all my routers, please let me know the script which I can run the same.My sample script is as follows.# by John Kull# import modules needed and set up ssh connection parametersimport paramik...

Hi, community. I want to set bandwidth limit only on Guest SSID on C9800 WLC. As configurable in Meraki AP.As a result, I can configure BDRL through ISE and AAA authentication, but I do not have both.In C9800 WLC, is it possible to set limit of avail...