Network Management

Hi AllI have seen that we can migrate the data from LMS 2.2 to 3.0. But can I do it frok Solaris to Windows?We have LMS 2.2 running on Solaris and now want to install LMS3.0 on Windows, will this work?In addition, we had LMS2.2 and HPOV NNM 6.31 runn...

Hi,I am recieving an error message for any device that I try to collect or archive a config on. I have tried to collect a single config by itself without any success. The error is telling me to increase my fetch settings which do not work or change ...

Hi all,To calculate MOS we need to configure IP UDP jitter with some codec. What oid should be checked to know that device supports this operation?Please help me!Thanks ahead

We have a main site where we want to deploy Ciscoworks LMS 3.0 and have many sites from which we want to pull data to populate the Ciscoworks at the main site.How can I go about deploying this effectively?Thanks

We know that we lost connectivity to a router and after connectivity was restored, we did a show log and did not get any entry for today. The dates are correct. What could be happening as we know that the serial interface went down? But nothing shows...

I have an ASA5510 for internet access. On the private side, it is on the same LAN as a 2800 series router with multiple GE interfaces, running two subnets. I want to NAT both the subnets from the 2800 series to the ASA5510 using a single dynamic NA...

I'm trying to setup up netflow to export to a collection server, but I don't see any traffic coming from the router in question to the collection server, nor do I see the flow information on the router itself when i use show ip flow cache. Any ideas...

Hi All,We have Cisco 7206VXR (NPE-G1) + IOS 12.2(25)S1 .I found problem with monitoring free RAM(processor) values.I normally get (over SNMP) all values, except Free Processor memory.(value from (SNMP - mem MIB) ~~ value from(SNMP - enhanced M...

Hi forum,i have a short question that i cannot answer within my lab.A costumer of mine wats to use a Compaq Proliant 320 with Windows Server 2003 as LMS 3.0 Server.Is it possible to use the Ethernet Adaper teaming for highavailiability?The Ethernet I...

Hi,When Cisco Works asks for SNMP community String, it gives two options: either SNMPv3 or SNMPv2c/SNMPv1. My question is that in the second choice, is Cisco Works using SNMPv2c by default or do I have to do something (Cisco Works or Catalyst 6509 sw...

I purchased a used 2950-24 router, but I didn't get the admin password. Is there any way to reset this?