Network Management

I have a Catalyst 6506-E SUP 32.I want to use a web interface to manage this device.I have got following files:cvdm-c6500-1.1.tar (Engine)cvdm-c6500chassis-19.0.tar (Chassis)and it's manuals.Manuals say that these interfaces don't support Super Eng...

Hi! This forum is my last hope to get replies for my questions.I have a Catalyst 6506-E:1 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX 2 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX3 3 Network Analysis Module ...

Hello,I?ve posted on here a couple times about my CiscoWorks LMS 2.5 problems. The gist of what I was hearing was that people thought I should upgrade to LMS 2.6 and that would hopefully solve the issuesPrevious post: http://forums.cisco.com/eforum/s...

Hi all.I'm running LMS2.5 on a restricted licencse, which is currently not an issue, but 'Device Discovery' is permantley running, therefore I cannot add new devices to the DCR.I've tried 'net stop crmdmgtd', restart the server, stop and start the pr...

Hi,Is RMON (as deployed on cisco switches and routers) able to monitor traffic flows as NetFlow does?Are there any devices that have full RMON support (except NAM)?Regards,Mladen

Hello,Does CiscoWorks have any kind of NTP capabilities? What I would like to do is point all my switches to the CWS to keep things centralized, while pointing the CWS itself to my NTP server. Is this feasible or just bad news all around (if it's eve...

Hello,Running RME 3.5 and had IDU 8 installed. Upgraded the IDU to 12 then 13 as in the PDF for the Solaris install. On restart the CW2K server is running but RME has no devices shown and I get database not started errors. On checking the dmgtd.log f...

After upgrading from LMS 2.51 to 2.6, the majority of our branch network shows as unconnected in Topology Services. The sites showing as unconnected have been set as seed devices, and can see our service providers on-site routers, via CDP. The switch...