Network Management

Hi,is there a chance to catch a guru here to help me filter out some very annoying messages on IOS XE SDWAN sw, that happen on console while vManage does some activity? Cisco TAC responded that he knows about "no logging console" only...ESM got on my...

Hello all,I have strange issue with new WS-C2960-48PST-L switch. When I'm trying add this device to Cisco Network Assistant (v.5.4) community I'm getting status message "Unsupported device type".I install this switch only with basic configuration (se...

Hi to All,i have added in Prime some  UPS devices , Prime recognises them via the ReadOnly community i have configured to these UPS.I have also configured them to send SNMP taps to Cisco Prime. Is there a way i can view these traps from these devices...

Hi,   Having trouble with adding cco credentials under administration/settings/system settings/General/Account Settings in Prime.   I want to check if it is due to the lack of internet connection on Prime. How do you check that?

I need to aggregate SPAN ports from multiple network segments into a single switch with uni-direction cable. Example. I have three independent/isolated three networks LAN-A, LAN-B & LAN-C.I need to take SPAN port from all three network and put it int...

Hi everyone, I use netconf to perform some configuration actions. For security reason I prefer to keep netconf turned off by default and only activate for short time. Activation is no problem for me - I do it with ansible.But it would be much easier ...

I'm facing issue in designing network for our machinery. We have 16 No's of machine connected to single UN managed HUB. If HUB failure happens we are facing communication issue and losing our production due to damaged products. Without server communi...

Can the Catalyst 3560C be upgraded to IP Services or is it limited to IP Base?I recently acquired a WS-C3560C-12PC-S for lab use and was hoping to enable IP Services to enable VRF-lite, however there doesn't seem to be an option to enable IP Services...

I have VSS setup and its working fine. Now I want to power off the standby switch so that we can reuse it other new location. I understand that there is a process of breaking the VSS config but it requires a downtime on both switches. Which I am tryi...

HelloI have the Cisco WS-C2960X-24PS-L 15.2(7)E3nothing is entered under dashboard monitoring clients.What could be the reason for this? Did I forget to configure anything on the 2960? Does it need any startup command to collect this information?THX

Hi,I've got got an ASR 1001-X where I want to export netflow data to a collector connected to the Management-interface of the ASR.Here's my setup wrt netflow:flow exporter Flow-to-collector destination 192.168.1.99 vrf Mgmt-intf transport udp 2601 ex...