Network Management

I want to increase the maximum available number of IP addresses that DHCP can allocate, but when I try to go beyond .149 it comes up with an error saying that  "PPTP IP and SSL IP" range overlap.   We do not need either of these, but I cannot find wh...

Hi, This is a low-tech question, but recently I've been getting numerous community string errors on our WAN switch. The ACL on our WAN interface has an ACE with "deny udp any any eq snmp"  - inbound - but I'm still getting the errors? What am I mis...

Hi All.It is possible to take some SHOW COMMANDS of devices/groups, in Cisco Prime Infrastructure 2.2 and then get this output.example:  a job for Router 2900 and execute show tech-support  and get this output.Thanks for your help.

Hi,   I would like to know if exist a Cisco Prime Infrastructure additional module or license for RFID and location services. In the users guide, regarded to the RFID page, you read: "This page is only available in the Location version of Prime Infra...

Hello Is my prime infrastructure server able to receive SNMPV3 traps and informs. And if so, how do i configure this?  thanks  dan 

Dear All, Kindly advise if we can setup and take archived configuration for ISE through Cisco Prime version 3.0?? Please elaborate. Best regards, Hikma

I have a simple template to specify logging servers for routers. When I push it out, it fails on saving the config to NVRAM. (I tried with and without the "exit" in the configuration with the same results.) Oddly, I can embedded "wr mem" into the tem...

Hello, My PRIME INFRA is full and I cant start NCS by SSH. How can I delete things older than 1 year by SSH?

I am trying to find the OID's needed to gather the following information. I am finding bits and pieces but not exactly what I need. Is there a way to get a full SNMP Walk of everything on a switch? Here is what I am hoping to get. Host NamePart Numbe...

Hello everyone. I'm using a flexible netflow for analyzing connections for security matters. But I have a lot of false allarms because my device sends netflow data before the flow itself is end. So I tryed to tune cache parameters to store data at t...

Dear All, I'm trying to create a script to schedule  a restart on my  VoiceGW (C2900) and send an email after each successful reboot. could you please help me with this. Thank you in advance.

I'm playing with Netconf on CSR1000v but I'm still unable to test YANG feature. I've added "netconf-yang" command into my configuration but when I establish ssh session I obtain the following capabilities only: $ ssh -2 -s cisco@10.105.139.154 netco...

One of our clients has prime infrastructure 2.2.It was an upgrade from WCS.During the upgrade they bought: WCS to Prime Infrastructure 2.x Upg 100 Device    L-W-PI2X-100-UNow they want to add additional devices (switches) so they need 50 additional l...