Network Management

Hello everyone, I would like to ask you some questions regarding some voltage issues. 1) where i could find voltage thresholds for the router ASR 1001-X 2) In my site, i have set up a monitoring tool, to monitor my network infra. So, I am receiving a...

Hi I would like to check if TX an RX did corresponde to the  Traffic In and Traffic out of a Total Bandwitdh. Example, I have a MPLS 50Mbps link, found out that the Traffic In is 28Mbps and Traffic out is 38Mpbs. Can I assume that these 2 traffic ha...

Hi Guys, Since there is no any part number in Cisco website for Cisco Prime Infrastructure, is there anyone who knows how to order it ? Regards

Hi,My Name is Rajeev, I want to restrict wireless device by using mac filtering in cisco wap321 after putting ip address in Block all station in list or Allow Only Station in list. I see that its not working,filter mac easily connect to network. Than...

hi Joe Clarke| Team i have a questions about the maxrun that it was define in EEM TCL scripting. From the cisco it said that "By default, all EEM policies should run to completion within 20 seconds. This 20 second timer is known as the maxrun timer.I...

Hi Gurus I would like to know how smart 'prime' is when it comes to deploying configuration changes.   Is there somewhere it can be made to check in the existing configuration for an element (e.g. an Interface config) and, only if a particular entry ...

Hi! Prime group switch ports as access, link and trunk ports automatically. Is there some way to force a "rescan and regroup", I have noticed that for some reason the grouping fails and some ports are ungrouped. I have seen it in different version 3....

Hi I have Prime Infrastructure 2.2 running with various managed Cisco devices, one of these devices is a 6509 chassis with dual sup 2T supervisors. When the active supervisor fails and we failover to the standby we are not receiving any notification...

Hello! In our company we are using dhcp snooping tables from switches for IPAM system(IP address management). Our company bought new cisco sg300-52mp switch and now i have a problem with snooping table, because it stores only in a flash memory of dev...

Hi! I'm exporting wireless maps from a 3.0 Prime system and importing them in a 3.1 system, this works ok. But, when importing Prime also create "network locations" and build Network topology maps based on the wirless structure campus, building floor...

We have a need to move the management IP address of Cisco 5508 WLC controller HA pair with ver 8.0.121.0. At present the management IP address is 192.168.1.10 /255.255.252.0 with vlan 10, needed to change to 172.168.1.10/255.255.255.0 with vlan100.  ...